User manual BLAUPUNKT TRAVEL PILOT 100 IBERIA

[. . . ] Long press: Start the Travelstore function. CD·C button - to activate CD mode or CD-changer mode (if connected). Display containing a segment display, fixed symbols and a dot-matrix field. Short press: Activates the navigation system. [. . . ] The destination that is stored on the button you selected is displayed. If you want to use the destination for navigation, press the OK button ;. For further information, read the section entitled "Navigation". 2 3 4 N1 NAVI DEN DESTN 3. . . NAV BERLIN, UNT ER DEN LIN Entering a destination - position marker You can use one of your preset position markers as a destination. A position marker is the vehicle position that you stored during your journey whilst the navigation CD was inserted but whilst navigation was inactive. So you can, for example, set position markers at interesting places that you want to return to at some other point in time. The navigation CD must be inserted in order to set a position marker (for further information, read the section entitled "Storing a position marker in the destination memory" in this chapter). Selecting a position marker as your destination Position markers are accessed in the destination memory in the same way as other destinations. For further information, read the explanation on "Entering a destination - from the destination memory". Navigation (route guidance) Starting navigation Once you have entered a destination, the destination address appears in the display. If you want to start a navigation session in order to be guided to this destination, 1 press the OK button ;. If you want to begin a navigation session to guide you to the last destination in a memory bank, 1 2 press the NAV button 7 repeatedly until the required memory bank containing the last destination appears in the display. Press the OK button ;. NEW DESTN. . . NAV BERLIN, UNT ER DEN LIN DEN FM 1 EUROPE TMC Route calculation After navigation is started, the system begins calculating the route. The traffic messages are received from TMC (Traffic Message Channel) stations. These are RDS stations that additionally broadcast their traffic messages in digital form. If you want to make a currently active navigation session dynamic, 1 button = pressed for longer than two seconds during the keep the navigation session. Dynamic navigation is active when TMC lights up in the display. Note: When in dynamic navigation mode, the system must be tuned to a TMC station during navigation. If no TMC station is set, TMC or button :. Start TMC seek tuning using the seek tuning can take a long time because the entire frequency range is scanned for TMC stations. Radio mode is not available during this time. Reading TMC messages The TravelPilot provides the option of displaying the traffic messages received via TMC (Traffic Message Channel) during dynamic navigation. 1 Keep the TRAF button @ pressed for longer than two seconds. INTRODUCTION NAVIGATION RADIO MODE CD MODE CD CHANGER SETUP FM 1 EUROPE 07p16 TMC B6/WESTSCH NELLWEG mi NAV 197 ENGLISH 26 PORTUGUÊS ESPAÑOL FM 1 EUROPE INTRODUCTION NAVIGATION RADIO MODE CD MODE CD CHANGER SETUP 198 The latest message appears in the display. [. . . ] Press the or button : to adjust the bass. When you have finished making your changes, press the AUD button ?or OK ;. BASS -2 RDS LD O3 45 TREBLE 3 RDS p m NAV Adjusting the treble To adjust the treble for the current audio source, 1 2 3 4 press the AUD button ?. Keep pressing the Press the or or button : until TREBLE appears in the display. [. . . ]