User manual BLAUPUNKT TRAVEL PILOT DX-R52A

[. . . ] the unit is protected by a quick-acting fuse of 5 A. Note: By means of the support included in delivery you can mount the set in cars with a DIN car radio cutout of 182 x 53 mm, an installation depth of 165 mm and an instrument panel thickness around the fixing clips of 1 - 20 mm, see fig. [. . . ] Use enclosed distance plates only for installation kits of 52 mm sets. Please check the dimensions and, if necessary, use a car-specific installation kit, e. Ground cable Do not connect the ground cable to the negative pole of the battery. Route the ground cable to a suitable ground point (car body screw, car body metal sheet) and shorten it accordingly. Remove the insulation from the ground cable and attach the forked cable lug (if necessary, solder it). Scratch off the paint from the contact area of the ground point and lubricate it with graphite grease (important for good ground contact). 7 Connection with multiple plug installed ex factory For vehicles with a system plug installed ex factory Blaupunkt offers an adapter cable for the common vehicle types, see fig. For Audi, Opel and VW vehicles an adaptor cable must be used although these cars have a pre-equipped ISO connector. otherwise the vehicle's electric system will be interfered. If the ISO plugs are directly connected (as currently done in vehicles from Citroën, Fiat, Honda, Lancia, Mercedes, Peugeot, Renault), then pin 1, 2 and 3 of the ± - plug must not be occupied. Connection with QuickOut installed ex factory If your car is fitted with a QuickOut ex factory (at present Opel), the QuickOut ex factory has to be removed. Insert the car radio from the front into the support and push in until the stop springs on the sides engage right and left (distinct click to be heard). [. . . ] Insert the brackets right and left into the provided trimplate holes and push in until you hear a distinct click (lateral springs are unlocked). Note: Locked brackets can only be removed after taking out the unit. [. . . ]