User manual BLAUPUNKT TRAVEL PILOT DX-R70A USA

[. . . ] - The cross sections of the positive and negative cables must not be less than 1. 5 mm2. - Incorrect installation may cause interference with electronic vehicle systems or your car radio. [. . . ] When you push in the system, make sure that you do not put any pressure on the display, the knobs or the keys! 1. 1 Radio antenna In pre-equipped vehicles (e. g. : VW, BMW, Audi), the antenna gets its power supply via the antenna wire (see the vehicle operating instructions). If you want to replace the OEM radio with the TravelPilot DX-R70, you will have to order compatible amplified antenna adapter. 1. 2 GPS antenna (satellite navigation) You will find information on how to install the antenna in the enclosed antenna installation instructions. If the GPS antenna is installed inside the vehicle, we cannot guarantee that the system will function correctly. 2. 4 Removing the TravelPilot Insert the handles into the corresponding holes on the left and right side of the front panel and push them in until you hear a loud click (unlocking the side spring locks). Use both handles to carefully pull the TravelPilot out of the compartment. Now you can pull out the connection cables by applying pressure on the side of the plug (see Fig. Note: Once the handles have locked into place, they cannot be removed until you pull the TravelPilot out of the compartment. The bracket included with this TravelPilot allows you to install the system in vehicles with a DIN car radio compartment measuring 182 x 53 x165 mm and an instrument panel which is 1 to 20 mm in the area where the fastener tabs are located, (see Fig. For the installation, you have to push the bracket into the compartment and determine which fastener tabs you can bend over with a screwdriver (see Fig. Note: Bend over as many of the fastener tabs as possible. 303 DEUTSCH ENGLISH 2. 2 Installing the bracket DEUTSCH ENGLISH 304 2. 5 Connecting the back-up light signal wire The back-up light signal wire connects the system to the vehicle back-up light. Make sure that this connection is charged with 12 volts when the vehicle is reversing. Important: We assume no liability for faulty connections and their consequences! 3. Connection diagrams Power connection to the vehicle ISO standard plug . . . . . . . . . 1/2 Power connection to the vehicle-specific plug . . . . . . . . . . . . 3 Speaker connection 4 speakers (4 /40 W) . . . . . . . . . . . . . . 4 Antenna connection . . . . . . . . . . . . . . . . . . . [. . . ] Lay the ground wire to a suitable ground (chassis screw, chassis metal) and screw it down. Speedometer signal Illumination connection Illumination connection for vehicles with variable instrument lighting (plus regulated). Continuous plus connection (terminal 30 battery + 12 V) Lay the plus wire (cross-section min. 1. 5 mm2) to the battery (not directly along the wire harnesses). [. . . ]