User manual BLAUPUNKT TRAVEL PILOT E1 D ROT

[. . . ] During operation of the unit, the set's side wall may heat up considerably. Be sure to keep all wires away from hot parts of the housing. Check the installation situation in the vehicle and, if necessary, use one of the special installation kits for specific vehicle models, e. [. . . ] Audi A4/A6/ A8: 7 608 021 473 Note: The mounting bracket included with this car radio is designed for installation in vehicles with a standard DIN installation compartment measuring 182 x 53 mm, 165 installation depth and an instrument panel thickness of approximately 1 to 20 mm in the area of the tab fasteners, see Fig. Reach behind the car radio compartment and check to see which tab fasteners can be bent for the mounting bracket. 5 Positive/negative connection with connection line 7 607 884 093 . 6 LF = left front, RF = right front, LR = left rear, RR = right rear. Connection in vehicles with QuickOut In vehicles equipped with a QuickOut (currently Opel), the QuickOut unit must be removed and the adapter cable used. Installing the car radio Place the car radio in the front of the mounting bracket and push it in until the side springs snap into position on the left and the right (you will hear an audible click). Removing the car radio Insert the handles into the holes in the panel on the left and right of the radio and push them in until you hear a distinct click (unlocks side springs). Pull the unit out using both handles, see Fig. Remove the paint of the ground contact surface and treat with graphite grease (important for a good ground connection). Brown / ground When connecting the positive line to terminal 15 of the fuse box (+12 V via ignition) behind the fuse, it will be possible to turn the system on and off via the ignition. Also, the unit will automatically switch off after one hour of playback time to avoid that the battery goes flat. This hour logic will not be activated when connecting the permanent +12 V line (terminal 30). Do not connect the vehicle's positive line !5 mm2 cross section to the battery (do not route close to vehicle harnesses). Connect the fuse box to protect the positive line and hook up to the positive terminal of the battery. If necessary, drill a hole into the splash wall and use a cable duct as required. [. . . ] If necessary, drill a hole into the splash wall and use a cable duct as required. If the vehicle has already been equipped with a 10 A fuse for radio connection at the factory, then the vehicle-specific adapter cable is required for hook-up only. The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 150 mA. [. . . ]