User manual BLAUPUNKT TRAVEL PILOT E1 W FRA

[. . . ] 30 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Changing the memory bank . . . . . . . . . . . . . . . . . 34 Storing stations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Any specialised dealer with the proper equipment can program the desired text with up to a maximum of 162 characters onto the KeyCard. Optical indication of anti-theft protection Flashing KeyCard tongue When the vehicle is stationary and the KeyCard removed, the KeyCard tongue can be switched to flash for extra anti-theft security. For this it is necessary that the positive power supply line and the permanent +12 V lead are connected such as described in the installation instructions. Be sure that "LED ON" is adjusted in the DSC mode. If required, please refer to chapter "DSC programming - LED". Switching off the flashing light If you would like to deactivate the flashing tongue in general, select "LED OFF" in the DSC menu. Using the SRC button you can switch between radio and tape operation. Tape operation is only available if a cassette is inserted. To switch to another source, · press SRC briefly. Turn On Message (T. O. M. ) Using the second KeyCard to be purchased at any specialised dealership, you can program the unit to display a selected "Turn On Message" after the set is switched on. Any specialised dealer with the proper equipment can program the desired text with up to a maximum of 48 characters onto the KeyCard. Each time you switch on your car radio using the second KeyCard, this text will appear in the display. Care of your KeyCard In order to ensure that the KeyCard always functions correctly, it is important for the contacts to be free from any foreign particles. If necessary, clean the KeyCard contacts using a cotton swab dipped in alcohol. 32 AF - Alternative frequency The AF (Alternative Frequency) function makes sure that the strongest frequency of the currently selected programme is always tuned in automatically. This function is activated when "AF" appears in the display. For this it is necessary that the stations have been tuned in at least once and that "AF" is active (lights up in the display). For this purpose, start automatic tuning, e. g. using Travelstore: · Press FMT or BND for 1 sec. ; the system starts to run through the frequency band. If "AF" does not light up, · press AF. This fulfils the requirements for selecting stations with << >>. Storing stations On FM, you can store six stations on the preset buttons 1-6 for each of the memory banks I, II and T. On MW/LW, you can also store six stations each. (only Bergamo RCR 148) · Select the desired memory bank. · Tune in a station with the rocker switch (either automatically / or manually << >>). Seek tuning Up Down << / >> Up/Down in short intervals (FM only, "AF" must be switched off) Manual tuning with << >> You can also tune in a station manually. Condition: AF and PTY must be switched off (i. e. the symbols do not light up in the display). If necessary, deactivate these functions: · Press AF or PTY briefly. Press and hold down the desired preset button until the radio resumes play after the muting (takes approximately 1 sec. , confirmed by beep). [. . . ] If you wish to alter any of the programming, · press SRC to select one of the operating modes radio or cassette (e. g. radio, if you wish to change the language with PTY LANG). Use the rocker switch to select and adjust the functions described in the following. The display will show you the adjusted condition. [. . . ]