User manual BLAUPUNKT TRAVEL PILOT E1 W SKA

[. . . ] During operation of the unit, the set's side wall may heat up considerably. Be sure to keep all wires away from hot parts of the housing. In some vehicles you will find a 20-pin connector pre-fitted in the dashboard's installation space. [. . . ] This connector must not be used for connecting the car radio! in vehicles manufactured by Audi and VW , the 8-pin positive/negative connector provided in the car must not be connected to a Blaupunkt radio directly!Otherwise the permanent +12 V line will be short-circuited to ground, leading to serious damage of the radio's internal circuitry (burn-out of printed conductor). 5 Positive/negative connection with connection line 7 607 884 093 . 6 Do not connect the control wire to terminal 15 (+12 V switched) or terminal 30 (permanent +12 V), maximum load < 150 mA. 7 LF = left front, RF = right front, LR = left rear, RR = right rear. If necessary, also use cables 7 607 647 093 and 7 607 648 000. 11 Connection in vehicles with QuickOut In vehicles equipped with a QuickOut (currently Opel), the QuickOut unit must be removed and the adapter cable used. Installing the car radio Place the car radio in the front of the mounting bracket and push it in until the side springs snap into position on the left and the right (you will hear an audible click). then strip the insulation and attach a cable lug (solder if necessary). Remove the paint of the ground contact surface and treat with graphite grease (important for a good ground connection). Brown / ground When connecting the positive line to terminal 15 of the fuse box (+12 V via ignition) behind the fuse, it will be possible to turn the system on and off via the ignition. Also, the unit will automatically switch off after one hour of playback time to avoid that the battery goes flat. This hour logic will not be activated when connecting the permanent +12 V line (terminal 30). Do not connect the vehicle's positive line !5 mm2 cross section to the battery (do not route close to vehicle harnesses). Connect the fuse box to protect the positive line and hook up to the positive terminal of the battery. If necessary, drill a hole into the splash wall and use a cable duct as required. [. . . ] If necessary, drill a hole into the splash wall and use a cable duct as required. The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 150 mA. When connecting a phone, the car radio will be automatically muted when making a call. [. . . ]