User manual BLAUPUNKT TRAVEL PILOT RNS3 FH

[. . . ] In doing so, observe the safety information provided by the vehicle manufacturer. Make sure not to damage any vehicle parts when you drill holes. The cross-section of the positive and negative wiring must not be less than 1. 5 mm2. [. . . ] You will find information on the installation and connection of the antenna in the antenna installation instructions. 5). 4. 3 Installing the TravelPilot Push all of the plugs into the sockets until they lock into place. Now insert the navigation system from the front into the bracket. Apply gentle pressure to both side edges and push it in until the spring locks snap into position on the right and left (you will hear a loud click). When you push in the system, make sure that you do not put any pressure on the display, the knobs or the keys! 3. 2 GPS antenna (satellite navigation) You will find information on how to install the antenna in the enclosed antenna installation instructions. If the GPS antenna is installed inside the vehicle, we cannot guarantee that the system will function correctly. 4. 2 Installing the bracket The bracket included with this TravelPilot allows you to install the system in vehicles with a DIN car radio compartment measuring 182 x 53 x 165 mm and an instrument panel which is 1 to 20 mm in the area where the fastener tabs are located, (see Fig. For the installation, you have to push the bracket into the compartment and de- 4. 4 Removing the TravelPilot Insert the handles into the corresponding holes on the left and right side of the front panel and push them in until you hear a loud click (unlocking the side spring locks). Use both handles to carefully pull the TravelPilot out of the compartment. Now you can pull out the connection cables by applying pressure on the side of the plug (see Fig. 7). 3 SVENSKA DANSK ENGLISH Installation instructions Note: Once the handles have locked into place, they cannot be removed until you pull the TravelPilot out of the compartment. 4 5. Connection diagrams Power connection to the vehicle ISO standard plug . . . . . . . . . 1/2 Power connection to the vehicle-specific plug . . . . . . . . . . . . 3 Speaker connection 4 speakers (4 /35 W) . . . . . . . . . . . . . . 4 Antenna connection . . . . . . . . . . . . . . . . . . . [. . . ] 150mA) Remote Control-In Remote Control-GND Fig. 9 Equalizer Amplifier RC 06 CD changer 7 SVENSKA DANSK ENGLISH Installation instructions Control cable (Power Antenna +) The control cable is the connected positive output for auxiliary components e. g. : power antennas, (maximum load < 150 mA). Do not connect the control cable to terminal 15 (Plus connected) or terminal 30 (continuous plus). 12V Relais 8 Wheel sensor (required for vehicles without a speedometer signal only) Plus connection (connected to the ignition) terminal 15 +12V This connection must be made via the ignition (terminal 15, +12V). 8 604 390 045 A Ground Do not connect the ground wire (min. [. . . ]