User manual BLAUPUNKT VA 2100

[. . . ] You can view the guarantee conditions at www. De or ask for them directly at: Blaupunkt GmbH Hotline Robert-Bosch-Str. D-31139 Hildesheim For additional information on the Blaupunkt product line visit our web site at: http://www. [. . . ] This ensures that every subwoofer is optimally separated as far as the frequencies it receives are concerned. If HP is selected, you can use the associated XOVER frequency control to adjust the lower cut-off frequency to between 50 Hz and 250 Hz. If you want to precisely optimise the acoustic settings of the XOVER, we recommend you obtain advice from a Velocity dealer. It is very important that you take into account the specifications of the loudspeakers being used whilst you are adjusting the XOVER. 361 x 60 x 300 If the XOVER is activated (LP or HP) by adjusting the position of the XOVER switch, you can then use the corresponding control to adjust the XOVER frequency of the respective filter to anywhere between 50 Hz and 250 Hz or 50 Hz and 250 Hz (i. The cross section of the positive and negative cables must be at least 6 mm2. Use cable grommets to protect cables against sharp-edged holes. Securely screw a standard 6 mm2 negative cable to an interference-free earth connection point (bolt connected to the car body, car body sheet metal) - though do not connect it to the negative terminal of the battery. Scratch the surface down to the bare metal at the point at which the earth contact is made and apply graphite grease. In order to obtain the best sound when a subwoofer is connected, the subwoofer must be separated as far as the frequencies it receives are concerned, i. It must only be fed with low frequencies (bass). Firstly, turn down the GAIN control on the amplifier to minimum and set the LOW PASS frequency control to its centre position. Now play some music on your car sound system that you are very familiar with and that contains some low bass (e. Now slowly increase the volume of the subwoofer by turning the GAIN control on the amplifier in a clockwise direction until you feel that the sound of the music is well balanced, i. The bass is neither too weak nor overpowering. Now listen to the relationship between deep male voices and the upper bass and also take note of the relationship between the upper bass (kick bass) and the lower bass. The bass should ideally sound crisp and have a clear low bass component, and male voices should neither sound too weak nor should they billow out. You can stop making adjustments if you are happy with the sound. [. . . ] Using the connecting rails, you can install several amplifiers next to one another to form a cool multichannel monster system with a convincing look. An additional advantage of the connecting rails and side pieces is plenty of storage space for avoiding messy bunches of cables. Our products are made from materials that can be disposed of in an environmentally sensitive manner and are suitable for appropriate recycling. [. . . ]