User manual BLITZ BZTV7R

[. . . ] Driving on extremely bumpy roads which cause severe vibration may cause the sound to skip. When the temperature of the unit falls such as during winter, the monitor screen will become darker than usual. Normal brightness will return after using the monitor for a while. Even in the event that trouble arises, never open the case, disassemble the unit, or lubricate the rotating parts. [. . . ] * The factory default setting is [NONE]. <Version 2> NONE -> RGB -> AV 1 -> AV 2 -> NONE [NONE] No navigation unit is connected to the unit. [RGB] RGB output of your navigation is connected to [RGB] input of the main unit. [AV1] AV output of your navigation is connected to [AV1] input of the AV control box. [AV2] AV output of your navigation is connected to [AV2] input of the AV control box. * The factory default setting is [NONE]. * Check the version of your unit and set up according to the version Watching the Picture of Navigation 1. The screen shows the picture of the navigation or press [MODE] button on the main unit repeatedly until [NAVI] mode is selected. *When your navigation unit is connected to AV1 or AV2 input of the AV control box, set up AV1/AV2 [ON] and then select AV1/AV2 mode to watch the picture of the navigation. *The car navigation system is an optional item. This unit only offers input for the system. Rear View Camera Operation with Touch Keys Setting Up 1. Touch [RVC] to select [ON] or [OFF] Each time [RVC] is touched, [ON] or [OFF] is selected. Select [ON] when a rear view camera is connected to [RVC] input of the AV control box. [SPDIF/PCM]: Outputs 2 ch digital signals through optical connection to a digital amplifier. * The factory default setting is [ANALOG] . * Select [SPDIF/RAW] or [SPDIF/PCM] when a digital amplifier is connected to the AV control box. AUDIO OUT Select audio output level. [LINE OUT]: Standard audio output level. [RF REMOD]: Increased audio output level. * The factory default setting is [RF REMOD] . OP MODE Select a desired audio output mode. [STEREO]: Stereo audio output [L-MONO]: Left audio output only [R-MONO]: Right audio output only. [MIX-MONO]: Left and right both audio output * The factory default setting is [STEREO] . DUAL MONO Set up Dolby Pro Logic [OFF]: Dolby Pro Logic Off. * The factory default setting is [ON] . PRO LOGIC Select according to PCM output frequency of your digital amplifier. [LPCM 48K] [LPCM 96K] * The factory default setting is [LPCM 96K] . LPCM OUTPUT 18 Preferences AUDIO Select a desired audio language. KOREAN, ENGLISH, FRENCH, SPANISH, CHINESE, JAPANESE *The factory default setting is [ENGLISH]. [. . . ] The illumination wire has not been connected. (If manual dimmer is set) The TV antenna and vehicle's radio antenna are to close. The fader or balance settings are set all the way to one side. The input/output wires or wiring harness are connected in correctly. No sound can be heard, or the volume is low. 30 Troubleshooting guide Problem The sound quality is poor or distorted. Possible Cause One of the speaker wires is being pinched by a screw in the car. [. . . ]