User manual BLUETREK M2

[. . . ] and is used by the manufacturer under license. PAGE 2 / 8 BEFORE USING YOUR HEADSET FOR THE FIRST TIME You must charge it continuously for about 4 hours, until the red indicator light turns off. Please refer to the "Charging the BLUETREK® M2" section of this manual. Please refer to the "Pairing BLUETREK® M2" section of this manual. Introduction The BLUETREK® M2 headset is a wireless headset based on the Bluetooth® technology. It complies with Bluetooth® 1. 2 protocol, supporting Headset and Hands-free profile. [. . . ] BLUETREK® M2, as packaged, is ready to be worn on your right ear. For left ear, simply unsnap the ear clamp from the headset by pulling gently at the base of the ear clamp ring. Flip the ear clamp over, and snap it back onto the headset by applying gentle pressure on the base of the ear clamp ring. The ear hook is made of a soft material which can be shaped to fit your ear. Please refer to the above diagram of how it can be adjusted. Switching the BLUETREK® M2 ON and OFF Switching BLUETREK® M2 ON When your headset is off, press and hold the TALK button for about 2 seconds until the blue indicator light is on. A beep (2 tones) can be heard in the speaker. To check if your headset is ON, press once on the TALK button. If the indicator light flashes blue, it means your headset is ON. Switching BLUETREK® M2 OFF When your headset is on, press and hold the TALK button for about 5 seconds until the red indicator light is on after the quick blue flashes. A beep (2 tones) can be heard in the speaker then release the TALK Button. PAGE 5 / 8 Making a call *Mobile phone with voice recognition . Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded with the phone. To enter these, please refer to your phone's manual . When there is no incoming or active call, press once on the TALK button . Wait for the audio signal sent by the mobile phone (generally a short tone). Speak the name of person you wish to call. Make sure both the headset and the mobile phone are ON and in stand-by mode. Dial the number on the phone keypad, after approximately 2 seconds the audio connection will be established. *This function may not be available on some phones, please refer to the trouble shooting frequent asked questions in our website: www. bluetrek. com. to find out more. Answering a call When the headset rings, press once on the TALK button to take the call. Ending a call Press once on the TALK button to end an active call. Adjusting the volume To increase the volume during an active call, press the "VOL+" button on the headset. To decrease the volume during an active call, press the "VOL-" button on the headset. Muting the microphone To mute the microphone during an active call During an active call, press and hold the VOL+ button for approximately 2 seconds. A periodic tone can be heard in the speaker when the microphone is muted. To end the mute function When the microphone is muted, quickly press the VOL+ button on the BLUETREK® M2. The periodic tone will end. Transferring a call from BLUETREK® M2 to the mobile phone During an active call, press the TALK button for about 2 seconds. [. . . ] Do not expose your headset to liquid or moisture. Do not expose your headset to extreme temperatures. Do not expose your headset to fire or open flames. Service and Maintenance can only be performed by authorized BLUETREK dealers. [. . . ]