User manual BLUETREK METAL EVOLUTION

[. . . ] It complies with Bluetooth® 2. 1 protocol, supporting Headset and Hands-free profile. The BLUETREK® Metal Evolution headset has 3 buttons: · "TALK" button (main button) · "Vol +" button · "Vol -" button "Vol +" button "Talk" button "Vol -" button BLUETREK METAL EVOLUTION I 1 Charging the BLUETREK® Metal Evolution Please insert the adapter in the main body. Then connect the USB connector to a powered USB slot. During the charge, the red Bluetooth indicator is switched on. [. . . ] You must then switch off your headset and start the pairing again. If pairing was successful, the indicator light will switch to blue and flashes slowly. The headset will connect automatically to the mobile phone. If the headset is not connected to the mobile phone for 20 minutes, the headset is switched off automatically. 4 I BLUETREK METAL EVOLUTION Making a call Mobile phone with voice recognition · Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded with the phone. To enter these, please refer to your phone's manual · When there is no incoming or active call, press once on the TALK button · Wait for the audio signal sent by the mobile phone (generally a short tone). · Speak the name of person you wish to call. Mobile without voice recognition · Make sure both the headset and the mobile phone are ON and in stand-by mode. · Dial the number on the phone keypad, after approximately 2 seconds the audio connection will be established. This function may not be available on some phones, please refer to the trouble shooting frequent asked questions in our website: www. bluetrek. com. to find out more. English Answering a call When the headset rings, press once on the TALK button to take the call. Ending a call Press once on the TALK button to end an active call. BLUETREK METAL EVOLUTION I 5 Adjusting the volume To increase the volume during an active call, press the "VOL+" button on the headset. To decrease the volume during an active call, press the "VOL-" button on the headset. English Muting the microphone To mute the microphone during an active call During an active call, press and hold the VOL+ or VOL - button for approximately 3 seconds. A periodic tone can be heard in the speaker when the microphone is muted. To end the mute function When the microphone is muted, press and hold the VOL+ or VOL - button for approximately 3 seconds. The periodic tone will end. Transferring a call from BLUETREK® Metal Evolution to the mobile phone With a phone in Headset Profile During an active call, to transfer it to the phone, simply turn off your headset. With a phone in Hands-Free Profile During an active call, to transfer it to the phone, double click the TALK button. 6 I BLUETREK METAL EVOLUTION Transferring a call from the mobile phone to the BLUETREK® Metal Evolution With a phone in Headset Profile Switch on your headset. With a phone in Hands-Free Profile During an active call on the mobile phone, double click the TALK button. This function may not be available depending on your phone. English Call waiting When you hear a call waiting alert while you are on a call, press approx. [. . . ] Turn off the headset, and then press and hold the Talk Button for about 5 seconds to enter into paring mode, pair it to the mobile B(please refer to "pairing" section). The 2 mobiles will be connected automatically. More information and Support Features many vary depending upon your mobile phone. You can check the compatibility on our website. You can also check with your phone manufacturer that your handset supports either handsfree or headset Bluetooth profiles. [. . . ]