User manual BLUETREK TATTOO

[. . . ] Please refer to the "Pairing the BLUETREK® TATTOO" section of this manual. Please connect the charger to the headset and to the main. During the charge, the indicator light is red. The indicator light will turn off when the charge is complete. During subsequent charges, the charging should take approximately 3 hours. [. . . ] A beep (2 tones) can be heard in the speaker then release the TALK button. English English BLUETREK TATTOO I 12 English English Making a call Mobile phone with voice recognition . Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded with the phone. To enter these, please refer to your phone's manual . When there is no incoming or active call, press once on the TALK button . Wait for the audio signal sent by the mobile phone (generally a short tone). Speak the name of person you wish to call. BLUETREK TATTOO I 6 Mobile without voice recognition . Make sure both the headset and the mobile phone are ON and in stand-by mode. Dial the number on the phone keypad, after approximately 2 seconds the audio connection will be established. This function may not be available on some phones, please refer to the trouble shooting frequent asked questions in our website: www. bluetrek. com. to find out more. Answering a call When the headset rings, press once on the TALK button to take the call. Ending a call Press once on the TALK button to end an active call. Adjusting the volume To increase the volume during an active call, press the "VOL+" button on the headset. To decrease the volume during an active call, press the "VOL-" button on the headset. 7 I BLUETREK TATTOO Muting the microphone To mute the microphone during an active call During an active call, press and hold the VOL+ button for approximately 2 seconds. A periodic tone can be heard in the speaker when the microphone is muted. To end the mute function When the microphone is muted, quickly press the VOL+ button on the BLUETREK® TATTOO. The periodic tone will end. Transferring a call from BLUETREK® TATTOO to the mobile phone During an active call, press the TALK button for about 2 seconds. This function only works in the Hands-Free Profile. In the Headset profile, you can simply turn off your headset. Transferring a call from the mobile phone to the BLUETREK® TATTOO During an active call on the mobile phone, press once on the TALK button to transfer the call. This function may not be available depending on your phone. BLUETREK TATTOO I 8 Fitting the Ergobud* 3 different sizes of Ergobud* are included in the pack to suit your ear size. You can adjust the Ergobud position that you feel the most comfortable. S M L To replace the Ergobud*, remove the speaker cover by pulling gently out from the speaker. Place the Ergobud* back onto the speaker by inserting the bottom part first. * Registered trademark pending 9 I BLUETREK TATTOO Replacing the "skin" To replace the "skin" simply peel off the sticker , from the edge of the sticker as shown in the diagram. Stick the new "skin" back to the headset slowly along the edge as shown in the diagram. Press the "skin" to ensure it is firmly adhered. Call waiting When you hear a call waiting alert while you are on a call, press approx. 3 seconds on the TALK button to accept the second call and place the current call on hold. To switch between an active call and a hold call, press approx. [. . . ] Do not dispose as household waste. GB Note on environmental protection: After the implementation of the European Directive 2002/96/EU in the national legal system, the following applies: Electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. [. . . ]