User manual BOMANN GS 7317 IX

[. . . ] Page 15 Special safety Information for this Unit. We hope you will enjoy using the appliance. Symbols in these Instructions for Use Important information for your safety is specially marked. it is essential to comply with these instructions to avoid accidents and prevent damage. [. . . ] The accessibility of the power plug must be ensured to disconnect the appliance from the power supply in case of emergency. Make sure that the voltage supply matches the specifications on the rating label before connecting. Connect the mains cable to a properly installed and earthed wall outlet. If the plug after installation is not accessible, a corresponding disconnect device must be available to meet the relevant safety regulations. Reversing the door opening If required, the door opening can be moved from the right (supplied condition) to the left side. WARNING: When replacing the door stop, the appliance must be disconnected from the power supply first. You possibly need: screw wrench, Phillips screw- Keep the parts to be replaced for another possible door stop change. Tilt the unit slightly backwards and lock it in this position. Unscrew the feet and disassemble the lower door hinge. Move and fasten the lower door hinge to the opposite appliance side. Put the appliance back in the upright position. Put on the appliance door and fix it in the intended position. Move and fasten the upper door hinge to the opposite appliance side after unscrewing the hinge pin and inserting it from the other hinge side. Put on the hinge cover (*delivery scope) and the blanking cap. Check that the door is optimally aligned both vertically and horizontally to ensure smooth opening and closing of the door. Dismount the door handle and attach it to the corresponding other door outer side. Refer to the instructions in "Assembling the door handle". Transfer the cover caps on the exposed holes to the respective other door outer side. Remove the hinge cover and the blanking cap. Dismount the upper door hinge and lift out the Transfer the doorstop on the door underside. CAUTION: After transport, the appliance should be left standing upright for four hours before connecting to the power supply. Nonobservance could lead to malfunction of the cooling system and causes an appliance breakdown. [. . . ] These can break when the contents freeze ­ or even explode, if they contain carbonated drinks. Once products have been defrosted halfway or completely, they should be consumed as soon as possible and should not be frozen again, except they have been processed to a ready meal. Keep closed the unit door in case of power failure. If the failure does not take longer than 20 hours, the food will not be affected. [. . . ]