User manual BONTRAGER NODE 2

[. . . ] NODE 1 & NODE 2 Owner's Manual. TM TM ENGLISH WELCOME. Thank you for buying a Bontrager NODE computer. We hope this computer gives you miles (or kilometers) of pleasure. TM Please read this manual carefully. If you do not understand the information, or you have a question that this manual does not cover, consult your Bontrager dealer or contact us. Safety When Riding When riding your bicycle, do not stare at the computer for a long time (Figure 1). If you do not watch the road, you could hit an obstacle, which may cause you to lose control and fall. Terms Used Hold Press Reset Trip Restart Scroll Toggle Press a button continuously for about three seconds. [. . . ] Zone 1 appears, showing the time spent in Zone 1 since the last Trip Restart. To return to HR, press 4. 5. Setting Heart Rate Zones 1. Hold for three seconds to go to Setting mode. Press . (or) (3 sec) 1. 2. 3. 4. To change the underlined digit, press To select, press . (or) or . Repeat step 5 for the other digits. To change the MAX number, press 6. 7. 8. To change the underlined digit, press To select, press . or . Repeat step 8 for the other digits. (or) 8. 9. To save and exit, press To go to Ride mode, hold . for three seconds. 9. CALORIE OUTPUT (CAL) This feature estimates the calories you are burning based on work and body weight (Figure 15). CAL is based on heart rate, so the sensor must be switched to ON and send a signal. Figure 15. Calorie Output Function. To View Calorie Output 1. Hold for three seconds to go to Setting mode. Press . (or) (3 sec) 1. 2. 3. 4. To change M (male) or F (female), press 5. To change WGT kg or lb, press (or) (or) 4. 5. 6. 7. To change the underlined digit, press To select, press . Repeat step 8 for the other digits. (or) 7. 8. INTERVALS (INT) Intervals are periods of time of a set length, separated by set periods of time. Interval Clock The interval clock runs separately from the Time function, so you can still use the stopwatch function and scroll through standard functions without stopping the interval clock. In the INT screen, there are two clocks above a box (Figure 16). When the clock on the left is running, it counts down the time that remains in the interval. When the clock on the right is running, it counts down the time that remains in the rest. The box gives the number of intervals that remain of the total repetitions, and a bar moves across the box to show the relative progress of the interval and rest clocks. Figure 16. Intervals Function. To View the Interval Clock 1. In Ride Mode, scroll to INT. 1. To Start the Interval Clock, or Restart at 0 1. [. . . ] Tighten the clamp screw on the back of the magnet (Figure 29) to secure the position of the magnet. Figure 26. Tighten the Clamp Screw. To Install the Cadence Magnet 1. Slide the cadence magnet (Figure 30) onto the crankarm with the magnet to the inside. Align the magnet with the cadence sensor. To Install the Sensor(s) Certain Trek and Gary Fisher road bikes feature a specially designed pocket that allows you to integrate a SpeedTrap sensor directly into the fork leg or a DuoTrap (Figure 32) sensor directly into the chainstay. [. . . ]