User manual BONTRAGER TRIP 1

[. . . ] You must first set the wheel sizes and choose the appropriate bike setting before riding. Trip Data (can be reset to 0 without affecting Odometer (ODO) total) · Trip Distance (TRP) · Average Speed (AVG) and Maximum Speed (MAX) · Ride Time (TME) WHEEL SELECTION Wheel 1 or Wheel 2 TRIP 4W ONLY SPEED Current Average (AVG) Maximum (MAX) TRIP 4W ONLY PACER TRIP 4W ONLY DISTANCE Trip (TRP) Odometer (ODO) Abbreviations and Screen Terms Abbreviation AVG CLK CUR MAX ODO TME TRP Meaning Average Speed Clock Current Speed Maximum Speed Odometer Ride Time Trip Distance Figure 2. Display Elements and Buttons. TIME Clock (CLK) Ride Time (TME) Easy Setup This procedure programs your Trip cycle computer for the first time or after a Reset. Install the Battery To prolong the life of the battery, it is not installed at the factory. (See Figures 9 and 10 at the end of the manual for further help installing the battery. ) To Set the Units You can program the wheel size, units, and time with just two buttons (Figure 2). Install the battery (or push the Reset button--see Figure 11 at end of manual). [. . . ] You can make your computer more accurate by setting a custom wheel size. To Set a Custom Wheel Size Measure the roll-out (Figure 6). Roll-out is the distance your bicycle travels in exactly one revolution of the wheel. If one wheel on your bicycle is bigger, measure the wheel with the magnet. Start with the valve stem of the wheel directly perpendicular to the floor. Placing an object on the floor makes a good mark. Roll the bike straight forward one revolution of the wheel, so that the valve stem is again directly over the floor. Mark the new location of the valve stem. Measure the distance between the marks in millimeters. The result is your Custom Wheel Size. Figure 6. Hold for two seconds until the wheel size appears. For Trip 4W, press M to select Wheel Size 1. Scroll to the four-digit number (example: 2050). (for 2 seconds) 1. 2. 3. 4. To change the flashing digit, press To select, press . Repeat step 5 for the other digits. The Trip returns to the TME display. (for 2 seconds) 6. Second Wheel Size (Trip 4W only) The Trip 4W can store two different wheel sizes. The icon for Wheel 1 is a small circle (Figure 7). Wheel 2 is a partial circle surrounding the Wheel 1 icon (Figure 8). Figure 7. Wheel 2 Icon. To Set the Second Wheel Size 1. To change to Wheel 1 or Wheel 2, press . (for 2 seconds) 1. 2. 3. 4. To set a custom a wheel size, refer to the instructions listed earlier in the manual. 6. (for 2 seconds) To Select the Wheel for Use 1. [. . . ] A coin or flat head screwdriver works well for this. Lift the battery cover, exposing the battery. Be careful to avoid losing the rubber O-ring seal. Insert the new battery with the `cross' and identifying label pointing up (Figure 10). [. . . ]