User manual BONTRAGER TRIP 2

[. . . ] You must first set the wheel sizes and choose the appropriate bike setting before riding. Trip Data (can be reset to 0 without affecting Odometer (ODO) total) · Trip Distance (TRP) · Average Speed (AVG) and Maximum Speed (MAX) · Ride Time (TME) WHEEL SELECTION Wheel 1 or Wheel 2 SPEED Current PACER TEMPERATURE DISTANCE Trip (TRP) Odometer (ODO) SPEED Average (AVG) Maximum (MAX) Abbreviations and Screen Terms Abbreviation AVG CLK CUR MAX ODO TME TRP CAD Meaning Average Speed Clock Current Speed Maximum Speed Odometer Ride Time Trip Distance Cadence Figure 2. Display Elements and Buttons. CADENCE (CAD) Trip 3 ONLY TIME Clock (CLK) Ride Time (TME) BACKLIGHT Trip 5W ONLY Easy Setup After you install the battery, you can program the wheel size and units. Install the Battery To prolong the life of the battery, it is not installed at the factory. (See Figures 10 and 11 at the end of the manual for further help installing the battery. ) To Program Your Trip This procedure programs your Trip cycle computer for the first time or after a Reset. If you would like to program individual features or advanced settings, see the sections Additional Information & Features and Advanced Settings. [. . . ] Scroll to CAD. 1. Advanced Settings This section explains how to set individual features of your Trip, and how to set advanced features including a second wheel size. To Set the Units of Measurement 1. The Trip returns to MAX. 4. 5. 6. To Set the Odometer 1. The odometer appears. (for 2 seconds) 1. 2. 3. To change the flashing digit, press To select, press . . 4. Repeat step 3 to change the other digits. The Trip returns to ODO. 3. 4. Custom Wheel Size The menu on your computer for tire size is based on averages, but there is some variation in actual tire size even between tires marked as the same. You can make your computer more accurate by setting a custom wheel size. To Set a Custom Wheel Size Measure the roll-out (Figure 7). Roll-out is the distance your bicycle travels in exactly one revolution of the wheel. If one wheel on your bicycle is bigger, measure the wheel with the magnet. Start with the valve stem of the wheel directly perpendicular to the floor. Placing an object on the floor makes a good mark. Roll the bike straight forward one revolution of the wheel, so that the valve stem is again directly over the floor. Mark the new location of the valve stem. Measure the distance between the marks in millimeters. The result is your Custom Wheel Size. Figure 7. Scroll to TME. for two seconds until the wheel size appears. Hold To program the second wheel size, press Set to change the preferred Wheel Selection icon to Wheel 1 or Wheel 2, and press M to select. Scroll to the four-digit number (example: 2050). (for 2 seconds) 1. 2. 3. 4. . To change the flashing digit, press To select, press . Repeat step 4 for the other digits. 5. (for 2 seconds) Second Wheel Size (Trip 4W only) The Trip can store two different wheel sizes. The icon for Wheel 1 (Figure 8) is a small circle. Wheel 2 is a partial circle surrounding the Wheel 1 icon (Figure 9). [. . . ] A coin or flat head screwdriver works well for this. Lift the battery cover, exposing the battery. Be careful to avoid losing the rubber O-ring seal. Insert the new battery with the `cross' and identifying label pointing up (Figure 11). [. . . ]