User manual BORETTI B402

[. . . ] Read all instructions carefully - save this instruction manual for future reference. Dear client , All of our products are always submitted to a strict quality control before they are sold to you. Should you nevertheless experience problems with your device, we sincerely regret this. In that case, we kindly request you to contact our customer service. [. . . ] Fill the milk reservoir with water between the "Min" and "Max" levels. Select one of the filters and place it on the porta-filter. Place the porta-filter in the unit Ensuring it is properly locked and place a cup under it. Also, make sure the tip of the frothed milk dispensing tube is inside the cup. Plug the appliance into the appropriate outlet. The three control panel lights will start blinking. Once these lights become solid, press the cappuccino button twice. Once this process is completed, the three control panels will turn on solid. Now your unit has been primed and is ready to be used. Fill the reservoir with water, you may either use a jar to fill it up or remove it from the unit And then fill it up under the tap. If you have removed it from the unit to fill up with water, please make sure to place it back tightly in its place. Fill the reservoir with the desired amount of water ensuring it ranges within the"MIN" and "MAX" markings on the tank. Never use warm or hot water to fill the water reservoir. Close the water reservoir lid and place it back in the unit ensuring it fits tightly. Filling the milk reservoir If you plan to prepare cappuccino or latte, remove the milk reservoir from the unit and open the lid then pour the quantity of cold milk you estimate you will need between the "Min" and"Max" levels. When done, place the milk reservoir back in the unit ensuring it fits tightly. Note: It is advised to use whole milk to get the best foam result. Choose the filter Select the filter to be used as follows: 1. FOR A SINGLE SHOT­ use the filter for a single shot of espresso if using ground coffee. FOR A DOUBLE SHOT OR TWO SINGLE SHOTS- use filter for a double shot. To insert the selected filter in the porta-filter, make sure to Align the notch on the filter with the groove inside the porta- 1 Turn the filter to the left or right to lock in place. This will help secure the filter in the porta-filter. [. . . ] After working for about 30min the six indicators quickly flash alternatly and then the user shall empty the water tank and refill it with 600ml clean water. After it, press the Espresso and Latte buttons simultaneously again and the appliance continous to perform descaling, at that time, the six indicators slowly flash alternalty. After working for about 30min, the appliance stops working and goes back to the standby condition. Empty the water reservoir and milk reservoir and fill the water reservoir with clean water for usage. [. . . ]