User manual BORETTI BVW96

[. . . ] Safety information Product description Control panel First use Setting the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function Select and start a washing programme 71 73 74 75 75 76 77 78 79 81 82 83 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Using no more than the correct amount of detergent contributes to reducing pollution. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the multitab function active. Simultaneously press and hold function buttons B and C , until the lights of function buttons A , B , and C start flashing. Press function button B , the lights of function buttons A and C go off while the light of function button B continues to flash. To activate the rinse aid dispenser, press button B again, the End indicator light comes on, indicating that the rinse aid dispenser has been activated. To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light goes off. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. The indicator light of the selected programme comes on. refer to 'Washing programmes' for more details. Close the appliance door, the programme starts automatically. Setting and starting the programme with delay start 1. After having selected the washing programme, press the delay start button until the indicator light corresponding to the chosen hours flashes (3h, 6h or 9h). Close the appliance door, the countdown starts automatically. Close the door; the countdown will continue from the point at which it was interrupted. Hot steam may escape when the door is opened. Close the door; the programme will start from the point at which it was interrupted. cancel a delay start or a washing programme in progress · Simultaneously press and hold the two function buttons B and C until all the programme lights come on. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. [. . . ] Water drain connection The end of the drain hose can be connected in the following ways: 1. to the sink outlet spigot , securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. The drain hose can face either to the right or left of the dishwasher Ensure the drain hose is not bent or squashed as this could prevent or slow down the discharge of water. [. . . ]