User manual BOSCH AKE 40 S

[. . . ] Die Kettensäge regelmäßig auf offensichtliche Mängel untersuchen, wie eine lose, ausgehängte oder beschädigte Sägekette, lose Befestigung und verschlissene oder beschädigte Bauteile. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. [. . . ] Important: The chain saw is not supplied filled with oil. It is essential to fill with oil before use. Never operate the chain saw without chain oil or at an empty oil tank level, as this will result in extensive damage to the product. chain life and cutting capacity depend on optimum lubrication. Therefore, the chain is automatically oiled during operation via the oil outlet 18. Filling oil tank: ­ Set chain saw on any suitable surface with oil filler cap 4 facing upward. ­ Clean area around the oil filler cap 4 with cloth, unscrew cap. ­ Add Bosch biodegradable chain saw oil until reservoir is full. ­ Avoid dirt or debris entering oil tank, refit oil filler cap 4 and tighten. Important: To allow venting of the oil reservoir, small breather channels are provided between the oil filler cap, to prevent leakage ensure machine is left in a horizontal position (oil filler cap 4 uppermost) when not in use. It is important to use only the recommended biodegradable oil to avoid damage to the chain saw. Use of non approved oil will invalidate the warranty. The voltage of the power source must agree with the value given on the nameplate of the machine. Machines designated for 230 V can also be operated with 220 V. For switching on the machine, press the lock-off button 3, then fully press the On/Off switch 2 and hold in this position. the lock-off button 3 can now be released. For switching off, release the On/Off switch 2. Do not stop chain saw after sawing by activating the front hand guard (kickback brake). When kickback occurs the chainsaw reacts unpredicably and can cause severe injuries to the operator or bystanders. Particular attention must be given when sawing sidewards, slanted or during length cuts, as the gripping teeth 11 usually can not be applied. to avoid kickback: ­ Saw with the chain bar at a flat angle. ­ Never work with a loose, widely stretched or the heavily worn out chain. [. . . ] If the chain saw should happen to fail despite the care taken in manufacturing and testing, repair should be carried out by an authorized customer service agent. Before returning, ensure all oil in the oil tank has been emptied. For all correspondence and spare parts orders, always include the 10-digit part number (TYP) from the nameplate of the machine!Clean the moulded plastic housing of the chain saw using a soft brush and clean cloth. [. . . ]