User manual BOSCH ART 26 COMBITRIM

[. . . ] S Work only in daylight or in good artificial light. s Avoid operating the trimmer in wet grass , where feasible. S Switch off when transporting the trimmer to and from the area to be worked on. S Switch on the trimmer with hands and feet well away from the rotating line. [. . . ] Products sold in GB only: Your product is fitted with an approved 13 A (BS 1363/A) electric plug and is protected by a 3 A fuse (ASTA Approved to BS 1362). If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a 13 A socket elsewhere. Note: The position of the wheels can be adjusted by loosening the wingnut 18 and moving to the desired position. B3 The wheels can be moved up and down the shaft 6 depending on the height of cut required. Pull the shaft out to increase the height, or push E Adjusting cutting head angle: To change the angle depress the foot pedal 12 and move the shaft 6 to the desired position. Do not connect the machine to the mains socket before it is completely assembled. A Mounting the Cutting Guard Place the cutting guard 10 on the trimmer head 7. Hook the guard onto trimmer head and push until secure fitting. Push rear of guard until secure (click). G Adjusting cutting head angle: Depress the foot pedal 12. move the shaft 6 to the lowest position. h Move trimmer head: Loosen the adjustment collar 5. Turn the shaft 6 90° to position the trimmer head 7 for trimming/edging as shown. Remove stones, loose pieces of wood and other objects from the cutting area. The cutting line continues to rotate for a few seconds after the trimmer is switched off. Allow the motor/cutting line to stop rotating before switching "on" again. I Cutting Grass Move the trimmer left and right, keeping it well away from the body. The trimmer can efficiently cut grass up to a height of 15 cm. When the line breaks off completely, feed twice to regain the full cutting circle. M If the line is exceeding the maximum cutting circle it will be cut by the blade 24 integrated in the cutting guard 10. Stop and remove plug from the power supply. [. . . ] Symptom Machine fails to operate Possible Cause Power turned off Mains socket faulty Extension cable damaged Fuse faulty/blown Extension cable damaged Machines internal wiring damaged Machine labours Machine is not cutting Line can not be fed Line keeps breaking Grass too high Line too short/broken off Spool empty Line inside the spool entangled Line inside the spool entangled Trimmer used incorrectly Remedy Turn power on Use another socket Inspect cable, replace if damaged Replace fuse Inspect cable, replace if damaged Contact Service Agent Contact Service Agent Cut in stages Feed the line manually/automatically Replace the spool Inspect the spool, rewind if necessary Inspect the spool, rewind if necessary Only trim with the tip of the line, avoid stones, walls and other hard objects. Feed the line regularly to maintain full cutting width. Power tools, accessories and packaging should be sorted for environmental-friendly recycling. Only for EC countries: Do not dispose of power tools into household waste! [. . . ]