User manual BOSCH ART 30

[. . . ] Read these instructions carefully, be familiar with the controls and the proper use of the line trimmer. Please keep the instructions safe for later use. Explanation of symbols on the line trimmer General hazard safety alert. S Never allow children or people unfamiliar with these instructions to use the trimmer. [. . . ] If the supply cord is damaged, it must be replaced by a Bosch Service Centre. Extension cords/leads should only be used if they comply with H05VV-F or H05RN-F types. Products sold in GB only: Your product is fitted with an approved 13 A (BS 1363/A) electric plug and is protected by a 3 A fuse (ASTA Approved to BS 1362). If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a 13 A socket elsewhere. Mounting the Wheels (ART 30/3000 COMBITRIM only) B1 Fit the wheels 11 onto the shaft 6. Note: The position of the wheels can be adjusted by loosening the wingnut 18 and moving to the desired position. B3 The wheels can be moved up and down the shaft 6 depending on the height of cut required. Adjustment C Using Adjustable Handle The adjustable handle 4 can be set in various positions: – To change the position undo the handle wing nut 3 and move the adjustable handle 4. — Tighten the handle wing nut 3 securely to fix the adjustable handle 4 in the adjusted position. d Adjusting Product length – Loosen the adjustment collar 5 90°. — Pull the shaft out to increase the height, or push the shaft in to decrease the height. E Adjusting cutting head angle: To change the angle depress the foot pedal 12 and move the shaft 6 to the desired position. Assembly Do not connect the machine to the mains socket before it is completely assembled. A Mounting the Cutting Guard Place the cutting guard 10 on the trimmer head 7. – Hook the guard onto trimmer head and push until secure fitting. G Adjusting cutting head angle: – Depress the foot pedal 12. — Move the shaft 6 to the lowest position. — Turn the shaft 6 90° to position the trimmer head 7 for trimming/edging as shown. English - 3 Cutting and Edging Remove stones, loose pieces of wood and other objects from the cutting area. The cutting line continues to rotate for a few seconds after the trimmer is switched off. Allow the motor/cutting line to stop rotating before switching “on” again. [. . . ] Place the Extra Strong Line spool 14 on the spool plate in the correct position (bayonet fastening), press down and turn fully clockwise (click). English - 4 O When the Extra Strong Line breaks, us the above procedure to remove the spool and fit the Extra Strong replacement Line 13 as shown to the spool. Replacement Extra Strong Line can be stored on the product as shown in main figure. n Refilling Line Take out the spool 25 as described above. [. . . ]