User manual BOSCH AXT RAPID 2200

[. . . ] Das Gerät regelmäßig auf offensichtliche Mängel wie lose oder beschädigte Messer, lose Verbindungen und abgenutzte oder beschädigte Teile untersuchen. Schlechte Schnittleistung Schneidemesser stumpf Schneidemesser verschmutzt Einfülltrichter oder Auswurfsschacht blockiert Schneidemesser dreht sich nicht Starke Vibrationen/ Geräusche Schneidemesser blockiert Messermutter/-schraube lose Messermutter/-schraube lose Schneidemesser beschädigt Gerät innen beschädigt Warning: Read these instructions carefully, be familiar with the controls and proper use of the machine. Please keep the instructions safe for later use. Before using for the first time, ask for a practical demonstration. [. . . ] Do not operate the machine on paved or gravel surface where ejected material could cause injury. Shredder Part number (TYP) Rated power, S 6 (4/6 min)1) Rated power, S1 No-load speed Capacity max. The S 6 operating mode (40 %) indicates a load profile of 4 min load and 6 min idle time. Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled. The blades continue to rotate for a few seconds after the machine is switched off. caution ­ do not touch rotating blades. Electrical Safety Your machine is double insulated for safety and requires no earth connection. Extension cords/leads should only be used if they comply with H05VV-F or H05RN-F types. If you want to use an extension cable when operating your product, only the following cable dimensions should be used: - 1. 5 mm2: max length 100 m It is recommended for increased electrical safety to use a Residual Current Device (RCD) with a tripping current of not more than 30 mA. Always check your RCD every time you use it. The couplings of connection leads must be protected against splashes and the coupling sockets on the leads must be made of rubber or coated with rubber. Fixing means for the connection leads must be used. The connection lead must be inspected for signs of damage at regular intervals and may only be used if in perfect condition. When operating the machine with a generator, a unit with a power rating of 4 kVA is necessary. Products sold in GB only: Your machine is fitted with an approved 13 A (BS 1363/A) electric plug and is protected by a 13 A fuse (ASTA Approved to BS 1362). If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a 13 A socket elsewhere. Rotate the On/Off switch 2 to position "II", allow the machine to start and release the switch. It will now move to position "I" (the normal run position). Important note: The machine will not start if the On/Off switch 2 is pushed in slightly, whilst being rotated. Blocking up of the cutter) can lead to a standstill of the machine after a few seconds. [. . . ] Stop and remove plug from the power supply. Note: To ensure long and reliable service, carry out the following maintenance regularly. Regularly check for obvious defects such as loose, dislodged or damaged blade, loose fixings, and worn or damaged components. check that covers and guards are undamaged and correctly fitted. [. . . ]