User manual BOSCH B1RKM09004

[. . . ] t Appliances of this kind contain refrigerants which need to be disposed of in accordance with current regulations. t Do not dispose of your old appliance yourself. Get in touch with your local council or other competent body for information about how best to dispose of it. t Read the instructions book before using your appliance for the first time. [. . . ] t Set the appliance to either the temperature control or dehumidification position. Do not forget to put the plug back in place on the drainage stopcock and to turn the stopcock 90° in a clockwise direction before setting the appliance to the temperature control setting. The appliance will shed water if you fail to do so. 8 Ways of releasing air outdoors Temporary installation t Connect the diffusion duct to the hot-air expulsion duct. t Open the window slightly and feed the diffusion duct through the gap. t Close the window as much as possible and secure it in place using the suction pad provided. Permanent installation The appliance can be installed on a permanent basis using window/wall Optional Accessory, reference B1 RKZ 06009, available from your supplier. t A hole must be made in the wall and the wall accessory fitted in order to expel hot air. t Store the diffusion duct away and connect the air expulsion duct to the accessory. t Only the transparent end section of the accessory is used when air is to be expelled through a window on a permanent basis. diameter hole must be made in the glass in order to fit the accessory. N. B. · Do not extend the hot-air expulsion duct more than necessary (maximum length: 140 cm. ). · There must be a distance of at least 70 cm. between the floor and the end of the duct. · Do not bend the duct too sharply when positioning it. This can impede proper hot-air expulsion, which may reduce cooling efficiency. 9 Dehumidification When set to , the appliance removes humidity from the atmosphere. It does not, however, control the temperature. t Turn drainage stopcock 90° in an anti-clockwise direction. t Remove stopcock plug and insert drainage pipe. t Place a bowl at the drainage pipe outlet to collect the condensed water in. t Put the air extraction duct in storage position. t Set control knob to dehumidification position . t The amount of water removed from the air can reach as much as 30 liters/24 hours, depending on atmospheric conditions. · Do not forget to put the plug back in place on the drainage stopcock and to turn the stopcock 90° in a clockwise direction before setting the appliance to the temperature control setting. [. . . ] (See instructions for Temperature Control). t Make sure that the drainage stopcock is set to the right position. t Make sure that the connections on hot-air expulsion duct are in working order. t Make sure that the expulsion duct is not excessively bent or longer than 140 cm. [. . . ]