User manual BOSCH BSD 3081

[. . . ] 2006 11:12 Uhr Seite 8 en Please keep this instruction manual When passing the vacuum cleaner on to a third party, please also pass on this instruction manual. … Never carry the vacuum cleaner by the power cord. … Fully extend the power cord when using the vacuum cleaner continuously for several hours. … When disconnecting the appliance from the mains, pull the plug, not the power cord. [. . . ] B) Disconnect the telescopic tube and adjust its length by moving the adjusting button/sliding sleeve in the direction of the arrow. Figure 6* Attach the accessories holder to the multipurpose nozzle and clip it onto the suction pipe/telescopic tube. If a fuse is be tripped when you switch on the vacuum cleaner, this may be because other electrical appliances which have a high current draw are connected to the same power circuit. To prevent the fuse from tripping, select the lowest power setting before switching the vacuum cleaner on, and increase the power only once it is running. 2006 11:12 Uhr Seite 10 en Figure 7 Holding the power cord by the plug, pull out the required length and plug it into the mains socket. Figure 8 Press the on/off button in the direction of the arrow to switch your vacuum cleaner on/off. Figure 9 Adjust the suction by turning the on/off button in the direction of the arrow. … Suction holds the drill dust nozzle in the required position. Depending on the surface of the wall to be drilled it may be necessary to readjust the power to a higher setting to ensure the drill dust nozzle is firmly attached. Any fine particles are automatically vacuumed up. Caution: The drill dust nozzle should only be used in conjunction with the dust collector since fine drill dust can impair the function of the dust bag. Vacuuming Figure 10 Adjusting the floor tool: a) Rugs and carpets b) Hard floors Figure 11* Vacuuming using the accessories (if required, connect them to the handle or the suction pipe). Figure 12* Ⅲ Secure the drill dust nozzle to the handle and then place against the wall, so that the nozzle drill hole opening sits directly over the hole to be drilled. … Select the lowest power setting and then switch on the vacuum cleaner. Figure 13 You can use the parking aid on the back of the vacuum cleaner if you wish to stop vacuuming for a short time. Slide the catch on the floor tool into the groove at the rear of the appliance. Figure 14 The appliance can also be carried using the two handles when vacuuming steps, for example. When the work is done Figure 15 Unplug the vacuum cleaner. Figure 16 To store or transport the vacuum cleaner, use the storage aid on the underside of the vacuum cleaner. Slide the catch on the floor tool into the groove on the underside of the appliance. You have purchased a floor vacuum cleaner which can vacuum up any type of dry dirt using the dust collector or dust bag. We recommend that you use: - the dust collector, in particular for your hobbies, e. [. . . ] Care Always switch off the vacuum cleaner and disconnect the power cord from the mains before cleaning the appliance. The vacuum cleaner and plastic accessories can be cleaned with a commercial plastic cleaner. Replacing the dust bag Figure 26 Ⅲ If suction diminishes considerably, the dust bag must be replaced, even if it is not yet full. In this case it is essential to change the dust bag due to the type of material it contains. [. . . ]