User manual BOSCH DHE635BGB

[. . . ] / DHE 645. . . en Operating and Installation instructions Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: de Tel. 650 2 Instructions for Use Appliance description Operating modes If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration. [. . . ] Position the filter screen against the housing and push upwards. Push in the lower edge over the brackets and lower the screen into place. 1. 1. 2. Check that the filter screen is securely located behind the retaining brackets on both sides. Using a screwdriver or similar, press the two lugs in the housing through to the back (only necessary upon initial fitting). Replacing the activated carbon filter: During normal operation (daily 1 to 2 hours) the activated carbon filter must be replaced approximately 1x year. The activated carbon filter can be purchased FROM YOUR DEALER (see Optional accessories). Only use original filters. These ensure optimum function. Disposal of the old activated carbon filter: Activated carbon filters do not contain any harmful substances. They can be disposed of as residual waste. 8 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the extractor hood with a hot soap solution or a mild window cleaner. Do not scrape off dried-on dirt but wipe off with a damp cloth. Do not use scouring agents or abrasive sponges. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Changing the bulbs 1. Switch off the extractor hood and deenergize by pulling out the mains plug or switching off the fuse. Press the edges of the lamp cover together where indicated and lift it out towards you. Caution: Ensure that the kitchen is adequately ventilated. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. 3. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder). Reinsert mains plug or switch on the fuse. Faults If you should have any questions or there are any faults, call customer service (see list of customer service units). Please give the following details when you call: Product no. (FD) Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. [. . . ] Observe the minimum distance from hob to extractor hood of 650 mm (the fixing screws must be fitted at least 1040 Important: If the door of the unit is at a distance from the body of the unit (e. g. due to rubber stops), the extractor hood must be drawn forward by the same distance. Mark the position of the lower fixing screws, predrill and fasten the screws. mm above the hob). 3. Predrill (with bradawl or 2 mm bit) and screw in the screws to 5 mm. 8. [. . . ]