User manual BOSCH DHI665V INSTALLATION INSTRUCTIONS

[. . . ] An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration. This rule does not apply to the use of cooking appliances, such as hobs and ovens. Unrestricted operation is possible if the extractor hood is used in recirculating mode ­ with activated carbon filter. Wall cupboard Filter frame Ventilator switches Light switch Pull-out vapour extractor Operating modes Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. [. . . ] 6 Filters and maintenance The filter can be cleaned in a dishwasher. This can however cause slight discoloration. Important: Metal filters that are heavily saturated with grease should not be cleaned at the same time as any crockery, etc. If the filter mat is going to be cleaned by hand, soak it first of all in a hot detergent solution for several hours. Clean the filter with a brush, rinse it off thoroughly and allow it to drip dry. In so doing you will be ensuring that the extractor hood performs as effectively as possible. Removing/inserting the metal grease filter: See details for removing/inserting the fleece filter. Hook the activated carbon filter into the left-hand side of the extractor hood housing, push the other side upwards and secure in place with the wing nut. Activated carbon filter: For neutralising odours when hood is used in recirculating-air mode. The activated carbon filter is installed above the grease filter inside the extractor hood. Remove the filter frame (see details on previous page). Place wing nut and sleeve over screw, insert into housing and tighten firmly (applies only when installing filter for first time). 4. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Pull out the extractor hood and detach the filter frame. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder). 4. Plug appliance into mains again or switch on at the fuse box. Installation Instructions: Important information Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. Before disposing of your old appliance, render it unusable. You received your new appliance in a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. [. . . ] Install a shelf immediately above the extractor hood. Cut holes for the pipe connection and the mains cable. 20 20 Important: The extractor hood must be firmly seated on the 4 mounting brackets. Align the extractor hood and then tighten screws. Check that the extractor hood is firmly fitted into the cupboard. mind. 15 75 mind. [. . . ]