User manual BOSCH DHL545S INSTALLATION INSTRUCTIONS

[. . . ] 2005 10:08 Uhr Seite 16 Instructions for Use Operating modes Exhaust-air mode ❑ The ventilator fan draws the vapours produced during cooking into the extractor hood, where they pass through the grease filter and out into the open air.  The grease filter absorbs the grease contained in the vapours produced during cooking.  The kitchen is kept almost totally free from grease and odours. Before using the first time ṇ The appliance is not intended for use by young children or infirmed persons without supervision. [. . . ] 2005 10:08 Uhr Seite 19 Filters and maintenance Extractor hoods with two filter cartridges: Warning: The halogen bulbs must be switched off and cool. Depress the detent on the grease filters in the direction of the arrow and fold down the grease filter slightly. Detach the grease filter by pulling it towards yourself. Activated carbon filter Removing and installing the activated carbon filter Extractor hoods with a filter mat: 1.  The wire grille is no longer required when an activated carbon filter is installed. Place the activated carbon filter on the filter mat and clamp it in. Insert the screw through the wing nut and the sleeve and screw in the middle screw in the false bottom (required only during the initial installation). Screw, sleeve and wing nut are enclosed with the activated carbon filter. Using a screwdriver, press in the two lugs on the false bottom. Insert the activated carbon filter at the rear, fold up and lock in the middle with the wing nut. If the spacer rail has been removed, it must be re-installed. Tape over the activated carbon filter with the enclosed sealing strip. Changing the activated carbon filter: If used normally (1 to 2 hours daily), the activated carbon filter should be changed approx. Activated carbon filters can be purchased from SPECIALIST OUTLETS (see optional accessories on the last page). Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants. 2005 10:08 Uhr Seite 21 Cleaning and care Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side.  At the same time as you renew the grease filter (see Filters and maintenance), clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.  Clean the extractor hood with a hot detergent solution or a mild window cleaning agent.  If the hood is extremely dirty (older stains), use a liquid window cleaner.  Do not scratch off dried-on dirt, but wipe off with a damp cloth. Warning: Clean the control buttons with a mild detergent solution and a soft, damp cloth only. [. . . ] D Exhaust air should neither be directed into a smoke or exhaust flue that is currently used for other purposes, nor into a shaft that is used for ventilating rooms in which stoves or fireplaces are also located. Local authority regulations must be observed when discharging air into smoke or exhaust flues that are not otherwise in use. D When the extractor hood is operated in exhaust-air mode simultaneously with a different burner which also makes use of the same chimney (such as gas, oil or coal-fired heaters, continuous-flow heaters, hot-water boilers) care must be taken to ensure that there is an adequate supply of fresh air which will be needed by the burner for combustion. Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. [. . . ]