User manual BOSCH DHU 632UFF/02 INSTALLATION INSTRUCTIONS

[. . . ] ä. , die Verbrennungsluft nachströmen kann. Bei nicht ausreichender Zuluft besteht Vergiftungsgefahr durch zurückgesaugte Verbrennungsgase. Ein Zuluft-/Abluftmauerkasten allein stellt die Einhaltung des Grenzwertes nicht sicher. Anmerkung: Bei der Beurteilung muss immer der gesamte Lüftungsverbund der Wohnung beachtet werden. [. . . ] Setting the required fan speed: Press the + button. Switching the fan OFF: Press the 0 button. Or: Keep pressing the ­ button until the fan switches off. Intensive setting: Maximum power is obtained at the intensive setting. It is only required for short intervals. Keep pressing the + button until a ç appears in the display. If the intensive setting is not cancelled by hand, the fan will automatically switch back to step } after 10 minutes. Filters and maintenance Removing and inserting the metal grease filters: Warning: The halogen bulbs must be switched off and cool. Press the catch on the grease filters inwards and fold the filters down. Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Removing the filter: Warning: The halogen bulbs must be switched off and cool. Press in the lug at the front and remove the activated carbon filter. 2. Do not use aggressive, acidic or caustic cleaners. Do not use abrasive agents. Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns. Remove the bulb ring with a screwdriver or similar tool. 3. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Take hold of the bulb with a clean cloth. 4. Plug the appliance into the mains or switch it on at the fuse box. Note: If the light does not function, check that the bulbs have been inserted correctly. 7 Installation Instructions: Important information Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. [. . . ] This extractor hood corresponds to EC regulations concerning RF interference suppression. We reserve the right to construction changes within the context of technical development. Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED IMPORTANT: Fitting a Different Plug: The wires in the mains lead are coloured in accordance with the following code: Green and Yellow ­ Earth Blue ­ Neutral Brown ­ Live If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals. Connect the green and yellow (Earth) wire to the terminal in the plug marked `E' or with the symbol ( ), or coloured green or green and yellow. Connect the blue (Neutral) wire to the terminal in the plug marked `N' or coloured black. Connect the brown (Live) wire to the terminal marked `L', or coloured red. [. . . ]