User manual BOSCH DHU 632UFF/03 INSTALLATION INSTRUCTIONS

[. . . ] 550 2 Instructions for use: Appliance description Chimney panelling Light / fan switches Operating modes This can be achieved if the combustion air is able to flow through non-lockable openings, e. g. in doors, windows and in conjunction with an air supply/air-intake wall box or by other technical procedures such as reciprocal interlocking. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. [. . . ] Keep pressing the + button until a ç appears in the display. If the intensive setting is not cancelled by hand, the fan will automatically switch back to step } after 10 minutes. Lighting: The light can be switched on at any time, even though the fan is switched off. 5 Filters and maintenance Removing and inserting the metal grease filters: Warning: The halogen bulbs must be switched off and cool. Press the catch on the grease filters inwards and fold the filters down. At the same time take hold of the underside of the grease filters with your other hand. Installation and removal: Warning: The halogen bulbs must be switched off and cool. Remove the metal filters (see "Removing and inserting the metal grease filters"). Insert the activated carbon filter. 2. Insert the clean filters back into the hood. 3. Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. Even for some time after the bulbs have been switched off there is still a risk of burns. Remove the bulb ring with a screwdriver or similar tool. 3. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Take hold of the bulb with a clean cloth. 4. Plug the appliance into the mains or switch it on at the fuse box. Note: If the light does not function, check that the bulbs have been inserted correctly. 7 Installation Instructions: Important information Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. Before disposing of your old appliance, render it unusable. You received your new appliance in a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. [. . . ] Connect the brown (Live) wire to the terminal marked `L', or coloured red. Electrical data: Are to be found on the name plate inside the appliance after removal of the filter frame. Before undertaking any repairs, always disconnect the extractor hood from the electricity supply. This extractor hood corresponds to EC regulations concerning RF interference suppression. 11 Installation This extractor hood is intended to be mounted onto the kitchen wall. [. . . ]