User manual BOSCH DWA095550B

[. . . ] . Operating and installation instructions Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: de Tel. 550 2 Gebrauchsanweisung: Gerätebeschreibung Kaminverblendung Schalter Licht / Lüfter Betriebsarten Dies kann erreicht werden, wenn durch nicht verschließbare Öffnungen, z. in Türen, Fenstern und in Verbindung mit Zuluft-/Abluftmauerkasten oder durch andere techn. Maßnahmen, wie gegenseitige Verriegelung o. [. . . ] Insert the clean filters back into the hood. Activated carbon filter: For neutralizing odours in recirculating mode. Warning: The halogen bulbs must be switched off and cool. Remove the metal filters (see "Removing and inserting the metal grease filters"). Insert the activated carbon filter. 3. Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 6 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. Do not use abrasive cleaning agents or sponges that could cause scratches. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Caution: Ensure that the kitchen is adequately ventilated. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. [. . . ] The extractor hood should only be connected to an earthed socket that has been installed according to relevant regulations. If possible, site the earthed socket directly behind the chimney panelling. 11 Installation This extractor hood is intended to be mounted onto the kitchen wall. Remove the grease filter (refer to Operating Instructions). Draw a line on the wall from the ceiling to the lower edge of the hood at the centre of the location where the hood is going to be mounted. [. . . ]