User manual BOSCH DWW 061461

[. . . ] 13 Operating Instructions Appliance description Chimney panelling Light / fan switches Operating modes This can be achieved if combustion air can flow through non-lockable openings, e. In doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. [. . . ] Insert an activated carbon filter on the right and left of the fan motor and rotate the filters until they lock into position. Insert the clean filters back into the hood. Insert the grease filters (see removal and installation of the metal-mesh grease filters). Removing the filter: The filters are removed in reverse sequence. Replacing the activated carbon filters: ❑ During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year.  The activated carbon filters are available from specialist outlets (see Optional accessories). The appliance is then guaranteed to function perfectly. Disposal of old activated carbon filters: ❑ Activated carbon filters do NOT contain any harmful substances. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. 17 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box.  At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.  Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood.  Do not scrape off any dirt that has dried on but loosen it up with a damp cloth.  Do not use abrasive cleaning agents or sponges that could cause scratches.  Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Press down the bulb cover and disconnect from the light strip. Clean the sliding switch with a soft, damp cloth (mild detergent solution) only. Do not use stainless steel polish on the sliding switch. stainless steel surfaces: ❑ Use a mild non-abrasive stainless steel cleaner. [. . . ] Using the template, mark positions on the wall for the screws. Note: Take into account any special accessories that are going to be fitted. Screw on the 2 brackets for fixing the upper and lower flue ducts. In order to help fix the hood onto the wall, screw in the middle screw (without a washer) until it protrudes by approx. [. . . ]