User manual BOSCH GSR 14-4-2-LI

[. . . ] Remove the battery before any work on the machine itself and before storing it. Before inserting the battery, when changing tools as well as when transporting and storing, always set the rotational direction switch to the centre position! convince yourself before using that the battery is securely seated in the machine. Do not strain the machine so heavily that it comes to a standstill. [. . . ] The machine is intended for the screwing in and loosening of screws as well as for drilling in wood, metal, ceramic and plastic. Typically the A-weighted sound pressure level of the product is less than 70 dB (A). The noise level when working can exceed 85 dB (A). S Hold the machine tightly: When driving in screws, high reaction moments can briefly occur. S Never allow children to use the machine. S Bosch is only able to ensure perfect operation of the machine if the original accessories intended for it are used. Open the drill chuck until the tool can be inserted. Hold the rear collar tight and firmly tighten the front collar by hand, until the "clicking" of the locking action is no longer heard. The locking is released again when the front collar is turned in the opposite direction to remove the tool. S The enclosed operating instructions for the battery charger must be read carefully!The chuck must be tightened with a torque of approx. S It is advisable to first drill a pilot hole before attempting to screw in large, long screws in hard material. Carry out a practical test to determine with which of the 5 settings of the torque setting ring 1 the screws are driven flush into the material. With the correct setting, the clutch disengages as soon as the screw is driven flush into the material or the set torque is reached. Select a higher setting when driving out screws, or set to the "Drilling" symbol. S Before any work on the machine itself, remove the battery. For safe and proper working, always keep the machine and the ventilation slots clean. If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service centre for Bosch power tools. In all correspondence and spare parts orders, please always include the 10-digit order number given on the nameplate of the machine. When releasing the On/Off switch 4 the speed of the drill chuck is reduced to a stop, thus preventing the run-on of the tool. [. . . ] When releasing the On/Off switch 4 the speed of the drill chuck is reduced to a stop, thus preventing the run-on of the tool. For screwdriving applications, wait until the screw is flush with the material and then release the On/Off switch 4. The screw head does not penetrate into the material then. These instructions are printed on recycled paper manufactured without chlorine. [. . . ]