User manual BOSCH GSR 14-4 V

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Liquid ejected from the battery may cause irritation or burns. 6) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Use appropriate detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Contact with electric lines can lead to fire and electric shock. damaging a gas line can lead to explosion. Penetrating a water line causes property damage or may cause an electric shock. Switch off the power tool immediately when the tool insert jams. Be prepared for high reaction torque that can cause kickback. The tool insert jams when: -- the power tool is subject to overload or -- it becomes wedged in the workpiece. Hold the machine only by the insulated gripping surfaces, when performing an operation where the cutting tool may run into hidden wiring. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. High reaction torque can briefly occur while driving in and loosening screws. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Take protective measures when dust can develop during working that is harmful to one's health, combustible or explosive. example: Some dusts are regarded as carcinogenic. Wear a dust mask and work with dust/chip extraction when connectable. Dust from light alloys can burn or explode. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. ) as well as during transport and storage, set the rotational direction switch to the centre position. Ensure the On/Off switch is in the off position before inserting battery pack. [. . . ] A battery that is new or has not been used for a longer period does not develop its full capacity until after approx. The battery is equipped with a NTC temperature control which allows charging only within a temperature range of between 0 °C and 45 °C. A long battery service life is achieved in this manner. A significantly reduced working period after charging indicates that the battery is used and must be replaced. [. . . ]