User manual BOSCH GST 85P

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] While reading the operating instructions, unfold the graphics page for the machine and leave it open. Typically the A-weighted noise levels of the product are: Sound pressure level 83 dB(A); Sound power level 94 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. It is suitable for straight and curved cuts with mitre angles to 45°. The saw blade recommendations are to be observed. 1 Rotatable top handle with pushbutton 2 Thumbwheel for stroke rate preselection (GST 85 PE) 3 Allen key 4 On/Off switch 5 Switch for sawdust blowing device 6 Adjusting lever for orbital action 7 Base plate 8 Guide roller 9 Saw blade* 10 Contact protector 11 Stroke rod 12 Splinter guard* 13 Scale for mitre angle 14 Screw 15 Angle gauge** Jigsaw Article number Stroke rate control Rated power input Output power Stroke rate at no load n0 Stroke Cutting capacity, max. in wood ­ in aluminium ­ in non-alloy steel Bevel cuts (left/right) , max. Weight according to EPTA-Procedure 01/2003 Protection class W W spm mm mm mm mm ° kg GST 85 P Professional 0 601 584 1. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until Dec. Before any work on the machine itself, pull the mains plug. When mounting the saw blade, wear protective gloves. [. . . ] Coolant/Lubricant When sawing metal, coolant/lubricant should be applied alongside cutting line because of the material heating up. Before any work on the machine itself, pull the mains plug. For safe and proper working, always keep the machine and ventilation slots clean. For this, remove the saw blade from the machine and lightly tap out the machine on a level surface. [. . . ]