User manual BOSCH HBA374BS0

[. . . ] –  ■ ■ ■ ■ ■ For the housing units, the sheets and plastic coatings must have been completed using an adhesive which is heatresistant at 90 ºC for the unit interior (where the oven will be positioned) and 70 ºC for the adjacent units (located to the side of the oven). If the sheets and plastic coatings or the adhesive do not have sufficient heat resistance, the units may become deformed or burned. [. . . ] If the oven is fitted below a hob, follow the hob's assembly instructions. Fitting the oven in a high unit: figure 2 The oven can also be assembled in a high unit. For ventilation, there should be a 20 mm gap approximately between the lower shelf and supporting wall and another 20 mm gap between the upper shelf and supporting wall. It is recommended that a gap of 590 mm is left between the lower and upper shelf for proper ventilation. This gap could be increased to 595 mm if you want greater ventilation than recommended. Ovens with a pull-out carriage door should be assembled so that the baking trays can be easily removed. Assembling the oven in a corner: figure 3 When assembling the appliance in a corner, the dimensions in figure D must be taken into account. It is recommended that for the measurements in figure E, the width of the front part of the unit and the handle are taken into account. –  ■ Before using the appliance for the first time, you must check that your house has an earth connection and fulfils all the applicable safety standards. Your appliance must be installed by an authorised technician. The requirements of the regional power supply company and national ones apply. The use of this appliance without an earth connection or when not installed correctly can cause serious damage (personal injury and death by electrocution), albeit this is highly unlikely. [. . . ] This is not necessary if the appliance is connected via a plug, if this is accessible to the user, and provided it is earthed. The assembly must ensure protection against manual contact. [. . . ]