User manual BOSCH HMT 35M653/01 INSTALLATION INSTRUCTIONS

[. . . ] · Refrigerator is designed for indoor household application only. Door and Hinge Removal Some installations require door removal to get refrigerator to final location. WARNING To avoid severe personal injury or death, observe the following: · Disconnect power to refrigerator before removing doors. Connect power only after replacing doors. · Green ground wire must be attached to top hinge while performing door removal and replacement. · Tape decorative panels (select models) securely into place before removing door handles. Measuring the Opening When installing your refrigerator, allow 1/2" space at top and 1/2" space behind machine compartment cover (located in the rear) for proper air circulation. [. . . ] Remove top hinges along with doors. 8. Remove bottom hinges with a 3/8" hex head driver. AB BA 3. Select models also have rear adjustment screws (B). Using the hex head driver, turn each of these adjustment screws (B) to raise or lower the rear of the refrigerator. Replacing the Doors · To replace the doors, follow the steps in Door and Hinge Removal in reverse order. Important: If water line tube end is damaged, cut off 5 /8" before reconnecting. 4. Using the carpenter's level, make sure front of refrigerator is 1/4" (6 mm) or 1/2 bubble higher than back of refrigerator and that the refrigerator is level from side to side. If required, correct rocking of refrigerator by turning rear adjustment screw clockwise to raise rocking corner. If doors are uneven, do the following: Cont. 4 Installation · Determine which door needs to be raised. · Turn front roller adjustment screw (A) clockwise to raise front corner of door. · If one refrigerator door has reached the limit of its adjustment range and doors are still not level, raise or lower the opposite door by turning roller adjustment screw clockwise or counterclockwise. Avoid kinks in the copper tubing when bending the service loop. Remove plastic cap from water valve inlet port. 2' diameter minimum 5 Installation 3. Place brass nut (A) and sleeve (B) on copper tube end as illustrated. The nut and sleeve are provided in the Use and Care packet. Place end of copper tubing into water valve inlet port. Do not kink ­ so that tubing feeds straight into inlet port. Slide brass nut over sleeve and screw nut into inlet port. Place adjustable wrench on nut (1) attached to plastic waterline and maintain position. Using second adjustable wrench turn the lower nut (2) counterclockwise and fully tighten while holding the upper nut in place. Pull on tubing to confirm connection is secure. [. . . ] Handle design varies from refrigerator to refrigerator. Please reference the appropriate instructions for your model. Cont. Grasp the lower part of the handle firmly, slide up, lift and remove from the surface. Release top door trim by removing Phillips screws from top of fresh food door, retaining screws for later use. [. . . ]