User manual BOSCH HSC 140P21/10

[. . . ] Remaining running time display Timer programming . Switching off automatically after the end of the programme Switching off the appliance . 13 Switching off rinse aid refill indicator . 14 3 en Intended use Cleaning and maintenance . [. . . ] The set value is saved. Terminatingtheprogram e Terminating the programme (Reset) 1. On the digital display H is indicated : . Switch off ON/OFF switch (. 24 Cleaning and maintenance en Cleaning and maintenance gC ne i nl a d n a en cm nti aa e A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. To ensure that the door seal always remains clean and hygienic, regularly clean it with a damp cloth and a little washing-up liquid. If the appliance is switched off for a prolonged period, leave the door ajar to prevent the formation of an unpleasant odour. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Remove cover completely. m Warning – Don’t forget: Repairs may be carried out by technicians only. If a component has to be replaced, ensure that only original spare parts are used. Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable risk. Waste water pump Large food remnants or foreign objects which were not captured by the filters may block the waste water pump. The rinsing water will then be above the filter. 6. Check impeller wheel and remove any foreign objects. Place cover in the original position and press down until it engages (click). m Warning – Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on pieces of broken glass or pointed implements. First always disconnect the appliance from the power supply. Take out top basket 1" and bottom basket 1b. 8. Re-insert baskets. 27 en Fault, what to do? Fault table Fault “Check water supply” display )" lights up. Remedial action Install supply hose without kinks. Switch off the appliance and pull out the mains plug. [. . . ] The hot water setting : allows you to adjust your appliance optimally to operation with hot water. It is recommended to have a water temperature (temperature of the incoming water) of at least 40 °C and no more than 60 °C. It is not recommended to connect the appliance to hot water if the water is supplied from an electric boiler. Rotate programme selector 8 until : is indicated on the digital display H. [. . . ]