User manual BOSCH IRA-20E

[. . . ] 'LVKZDVKHU 9000 209 459 (9009) HQ 2SHUDWLQJ LQVWUXFWLRQV en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 15 15 15 15 15 16 16 16 16 16 16 17 17 18 18 18 19 19 20 21 21 21 22 22 22 23 23 23 23 24 24 24 24 24 Safety instructions . 7 Switching off water softening system . [. . . ] glasses, cups, plates), you can switch to "half load". It is recommended to put a little less detergent in the detergent dispenser than for a full load. End of programme The programme has ended when the programme cycle display P has gone out and the programme end display X lights up. Several minutes after the end of the programme: ­ Switch off the main switch (. ­ After letting the device cool down take out the dishes. ­ Close the door. Switching off the appliance Short time after the end of the programme: ­ Switch off the main switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. 15 en ã=Warning Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. ­ Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. Interrupting the programme ­ Switch off the main switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the main switch ( again. Terminating the programme (Reset) ­ Only when the main switch is on: Rotate programme selector 8 to the Reset position. ­ The programme sequence lasts approx. [. . . ] ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. Fresh water connection ­ Connect the fresh-water connection to the tap according to the installation instructions with the enclosed parts. Ensure that the fresh-water connection is not kinked, crushed or twisted. [. . . ]