User manual BOSCH KAD 62S51TI/03

[. . . ] The dispenser agitator is not designed to be an ice crusher. Use of large chunks of ice which "jam up" inside the hopper will cause failure of the agitator motor and damage to the hopper. If bagged ice is used, it must be carefully and completely broken into small, cube-sized pieces before filling into the dispenser hopper. May 2002 Page 3 ID150, ID200, KAD 62S51TI/03 INSTALLATION 1. Locate the ice dispenser on the counter. [. . . ] Use the tubing, fittings, clamps, and insulation provided with the Dispenser to assemble the drain. The completed drain line must pitch continuously downward and contain no "traps" or improper drainage will result. NOTE: This equipment must be installed with adequate backflow protection to comply with federal, state, and local codes. May 2002 Page 4 ID150, ID200, KAD 62S51TI/03 WATER GLASS FILLER KIT Installation Instructions WARNING: Disconnect power to unit before proceeding with installation 1. Prepare unit as follows: ·Remove lower front panel. ·Locate new holes in front panel. 2. Install faucet and tubing assembly as shown below. Connect field water supply to ¼ male flare fitting on tubing assembly. Apply water pressure and check all connections for leaks. Check that tubing assembly does not interfere with wiring or electrical components. Carefully reinstall panels on unit. May 2002 Page 5 ID150, ID200, KAD 62S51TI/03 WATER GLASS KIT - CONTINUED ID150 A B 4" 2. 5" ID200, KAD 62S51TI/03 A B 6 1/8" 3 1/8" Water inlet can be routed either from the back or from underneath the dispenser. If from the back, remove the back and bottom access panels. CLEANING PRECAUTIONSS WARNING: Disconnect Power Before Cleaning!Do not use metal scrapers, sharp objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage may result. Do not use solvents or other cleaning agents, as they may attack the plastic material. Soap solution - Use a mixture of mild detergent and warm (100 degrees F) potable water. May 2002 Page 10 ID150, ID200, KAD 62S51TI/03 CLEANING AND SANITIZING MONTHLY & INITIAL START UP: Sanitize the Ice Storage System. Note: this should only be done by qualified personnel. CLEANING PRECAUTIONS WARNING: Disconnect Power Before Cleaning!Do not use metal scrapers, sharp objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage may result. Do not use solvents or other cleaning agents, as they may attack the plastic material. Soap solution - Use a mixture of mild detergent and warm (100 degrees F) potable water. Unplug the electrical cord from the electrical power. Remove cover and discard all remaining ice. [. . . ] Using a mechanical spray bottle filled with sanitizing solution, spray the entire interior and agitator assembly. Re-assemble ice chute assembly. May 2002 Page 11 11. Using a mechanical spray bottle filled with sanitizing solution, spray the inside of the ice chute. Wipe the top edge of the ice hopper with the sanitizing solution, allow to air dry. [. . . ]