User manual BOSCH KAD 62V40AU/01 SHORT INSTRUCTIONS

[. . . ] Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the User Manual and this Installation Guide in a safe place for future reference. Black units have drawers with black glass fronts, sculpted handles and black vinyl-clad cabinets. Stainless Steel units have drawers with stainless steel framed fronts, sculpted stainless steel handles and black vinyl-clad cabinets. [. . . ] Stain must penetrate approximately 3 minutes. After this period, while stain is still wet, take a stain-dampened rag and remove all excess stain. Wipe in the direction of the grain with medium pressure to achieve the desired stain color. After 2 hours, repeat Step 4. CAUTION To prevent permanent damage to the inner liner of the Wine Captain®, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer's instructions prior to re-installing the wood trim inside the cabinet of the Wine Captain®. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty. Adding a Final Finish Coat to Wood Trim IMPORTANT Do not remove the two racks attached at the drawer slides. Remove wine caddy, the top two racks in the upper drawer and the top rack in the bottom drawer (remove each wine rack by sliding it out and up). Remove and save screws securing wood trim to the racks and caddy. Remove and save screws Figure 5 securing wood trim to the two racks attached at the drawer slides (without removing these racks themselves). Lightly scruff sand the wood trim with 280 grit 3M Tri-M-Ite sandpaper. Apply a thin coat of Minwax Polycrylic, following container label for directions. Repeat procedure for the other slide. Front-to-Back Adjustment See Figure 11. The drawer will need a Front-to-Back Adjustment if, when viewed from the side, the drawer front is cocked forward or back. This is caused by the front slide mountings not being level with the rear slide mountings. Not Aligned Front-to-Back Side View of Unit Figure 11 02/2005 9 www. U-LineService. com 2075DWRWC -- Drawer Model Wine Captain® TM Top-to-Bottom (and Left-to-Right) Adjustment Not Aligned Top-to-Bottom Severe Adjustment: Note: The slides have extra mounting holes that may be used. Remove one slide's mounting screws. Reposition the slide so it is the same distance from the bottom of the liner as the other slide. Measure to confirm. Mark and Drill New Mounting Holes Push Slide Upward or Downward Not Aligned Left-to-Right Top View of Unit Front View of Unit Figure 16 3. Mark new drilling holes using different sets of mounting holes on the slide. Corresponding rear holes will also need to be marked. Drill all the new holes with a #30 drill bit. Figure 14 See Figure 14. The drawer will need a Top-to-Bottom Adjustment if, when viewed from the front, the drawer is not level horizontally. Viewed from the top, one side will protrude. [. . . ] After leveling, the unit must be secured to a counter, a cabinet or a wall to prevent tipping. Open the upper drawer to expose the six screws (A) installed at the top two corners (three at each corner). Remove the appropriate screws for horizontal or vertical mounting (see Figure 20). Do not discard. C Vertical Mounting (Left Side Shown) Cabinet or Wall Stud B C A Figure 20 www. U-LineService. com 12 02/2005 TM 2075DWRWC -- Drawer Model Wine Captain® 2. [. . . ]