User manual BOSCH KSW30V80TI

[. . . ] 8 8 9 9 9 10 10 11 12 13 en Index Information concerning disposal . Note ambient temperature and ventilation . 14 14 16 16 16 17 17 17 18 18 18 Use temperature zones in the refrigerator compartment!Switching off and disconnecting the appliance . [. . . ] 2 Place the appliance in the designated location and align. The front screw feet can be adjusted. 16 en Note ambient temperature and ventilation The climatic class can be found on the rating plate. It specifies the ambient temperatures at which the appliance may be operated. Climatic category Permitted ambient temperature +16 _C to 32 _C +16 _C to 38 _C +16 _C to 43 _C Connecting the appliance After installing the appliance, wait at least 1 hour until the appliance starts up. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior of the appliance (see chapter Cleaning). Connect the appliance only to 220­240 V/50 Hz alternating current via a correctly installed earthed socket. The socket must be fused with a 10 A to 16 A fuse. If the appliance is to be operated in a non-European country, check on the rating plate whether the indicated voltage and current type correspond to the values of your mains supply. The rating plate is situated in the bottom left-hand side of the appliance. The power cord may be replaced by a technician only. !Warning Never connect the appliance to electronic energy saver plugs or to power inverters which convert the direct current to 230 V alternating current (e. g. solar equipment, power supplies on ships). N ST T ! Attention The room temperature must not drop below +16 _C. Otherwise the refrigerator compartment will become too cold and perishable items may be damaged. Ventilation Fig. 3 The heated air on the side panels of the appliance must be able to escape freely. Otherwise, the refrigerating unit must work harder and the power consumption is increased. For this appliance there must be a 4 cm gap between the wall and adjacent furniture. This distance is also required so that the door can be opened by at least 90_. 17 en Switching on the appliance Press the On/Off button Fig. Interior light is switched on when the door is open. At the factory the appliance has been set to the middle setting (3) Refrigerating capacity The temperature in the refrigerator compartment may rise temporarily if loaded with fairly large amounts of food. Placing bottles in the refrigerator Note when loading products: S Depending on the model, a max. number of bottles can be stored on the bottle shelves, see loading example, Figs. This number of bottles can be stored if the bottles are placed with their necks facing forwards. [. . . ] Change the bulb: Replacement bulb 220--240 a. c. , E14 bulbholder, see defective bulb for wattage. Light switch is sticking. Floor of the The condensation refrigerator drainage pipe is compartment is wet. A lot of bottles were placed in the appliance. Check whether it can be moved. Clean the condensation channel and the outlet (see "Cleaning the appliance") Do not open the door unnecessarily. [. . . ]