User manual BOSCH KTR15NW4A

[. . . ] 20 Switching off and shutting down the appliance . This appliance complies with the relevant safety regulations for electrical appliances and is fitted with noise suppression. The refrigeration circuit has been checked for leaks. about these instructions Read and follow the instructions for installation and use. [. . . ] In the case of appliances operated outside of Europe, check whether the voltage and type of current specified conform to the values of your electricity grid. You will find this information on the rating plate. m Warning The appliance must never be connected up to an electronic energy-saving socket. Sinusoidal-commutated and line-commutated inverters can be used with our appliances. Line-commutated inverters are used with photovoltaic systems that are connected directly to the national grid. Sinusoidalcommunicated inverters must be used with standalone applications (e. On ships or mountain huts) that do not have a direct connection to the national grid. Note To ensure that it functions properly, the appliance must be aligned using a spirit level. Move the appliance into its intended installation Screw the feet in/out until the appliance is exactly Open the appliance door and unhinge and remove all fittings from inside the appliance (see section headed Fittings). Take off the cover plate (2) and set it down on a We recommend to have the door hinge changed by our customer service. How much a door hinge change will cost you can find out contacting customer service. m Warning When the door hinge is changed, the appliance must not be connected to the power supply. Unhook the appliance door and set it down on a soft surface. Place the appliance carefully onto its rear side. Unscrew the nut (9) and pull out the bolt (10). Mount the cover panel (2) at the front and lay it flat on the rear. Insert the bolt (10) into the left boring and apply the nut (9) and tighten. Apply the bottom hinge (8) and apply 3 the screws (7) and tighten. Screw the feet (6) into the bottom hinge (8). Open the appliance doors and attach all fittings (see section headed Fittings). Getting to know the appliance appliance The features of the models may vary. The illustrations may differ from your particular model. [. . . ] The appliance door is being opened Do not open the appliance door The ventilation openings are covered. Placing large quantities of food in the Set a lower temperature. The appliance is too close to a heat See section headed Installing the appliance. Source or the ambient temperature is too warm. [. . . ]