User manual BOSCH MKKR18V60A

[. . . ] 23 Switching off and disconnecting the appliance . Safety and warning information Before you switch ON the appliance please read the operating and installation instructions carefully!They contain important information on how to install, use and maintain the appliance. The manufacturer is not liable if you fail to comply with the instructions and warnings. [. . . ] The delivery consists of the following parts: Built-in appliance Interior fittings (depending on model) Bag containing installation materials Operating instructions Installation manual Customer service booklet Warranty enclosure Information on the energy The appliance is designed for a specific climate class. Depending on the climate class, the appliance can be operated at the following temperatures. The climate class can be found on the rating plate. The appliance is fully functional within the room temperature limits of the indicated climatic class. If an appliance of climatic class SN is operated at colder room temperatures, the appliance will not be damaged up to a temperature of +5 °C. The air on the rear panel of the appliance heats up. Conduction of the heated air must not be obstructed. Otherwise, the refrigeration unit must work harder. Therefore: Never cover or block the ventilation openings!If the cavity depth is smaller ­ at least 550 mm ­ the energy consumption increases slightly. installation location Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: After installing the appliance, wait at least 1 hour until the appliance is switched on. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior of the appliance (see chapter "Cleaning the appliance"). electrical connection The socket must be near the appliance and also freely accessible following installation of the appliance. The appliance complies with the protection class I. Connect the appliance to 220­240 V/50 Hz alternating current via a correctly installed socket with protective conductor. The socket must be fused with a 10 to 16 A fuse. For appliances operated in nonEuropean countries, check whether the stated voltage and current type match the values of your mains supply. This information can be found on the rating plate. Getting to know your appliance please fold out the illustrated last page. [. . . ] It is not necessary to wipe off the condensation or frost. The condensation runs into the condensation channel, Fig. And is conveyed to the refrigerating unit where it evaporates. Note Keep the condensation channel and drainage hole clean, so that the condensation can run out. [. . . ]