User manual BOSCH MUM-54720

[. . . ] This appliance is not for use by children. Close supervision is necessary when any appliance is used near children. Do not leave appliances unattended during operation. Unplug from outlet when not in use, before putting on or taking off parts and before cleaning. [. . . ] When doing this, always place the liquids in first. When adding ingredients to a mixture: a. Turn the rotary switch to a lower speed; b. Remove the cover from the splash ring; c. Add the ingredients through the cover opening and replace the cover. If a large batch of dough is to be left in the mixing bowl and allowed to rise, the cover and splash ring should be removed and placed loosely on the bowl so that it is free to move if the dough should begin to press on it. 13 3. Place and engage the twin beating whisk assembly on the driveshaft of the mixing bowl as shown in figure 6. Figure 6. 4. Place the splash ring on the cover, making sure the tabs on the bowl fit into the recesses in the splash ring, and turn counterclockwise, see figure 5a. Then place the cover on the splash ring so that the tabs on the splash ring fit into the recesses in the bowl cover and turn the cover counterclockwise to fasten the bowl cover to the bowl. See figure 5b. Removing Contents Before beginning to remove the contents from the mixing bowl, make sure that the power unit has been turned to the Off position, "O/Off. " Remove the cover and splash ring by turning clockwise and lifting off. Once the cover and splash ring have been removed, the dough hook or the twin beating whisks may be removed by turning the hook or whisk assembly clockwise while lifting. Remove the blade/base assembly from the blender, see figure 9. Figure 9. To assemble or reassemble blade/base assembly into the blender, insert the blade/base assembly into the blender jar and press down on the blade/base assembly. Turn clockwise to the stop, see figure 11. The blade/base assembly is then back in place. CAUTION Blade/base assembly is very sharp. The blade/base assembly may be easily removed by inverting the blender and using the blender cover to fit over the tabs on the blade/base assembly. Turn it counterclockwise until it stops, see figure 9a, and then lift up, figure 9b. Wash the blade/base assembly under running water. Do not place the blade/ base assembly in the dishwasher or allow it to stand in water. This will tend to wash out the lubricant. After cleaning, rinse thoroughly and dry before using. 15 Figure 10. 3. If you have not already done so, move the motor drive cover to the high-speed drive. [. . . ] Turn on power and gradually add Parmesan cheese, garlic and basil leaves. Toss with cooked pasta or spread on bread or crackers. 1 Place all ingredients in Bosch mixing bowl. Thoroughly knead on speed 1 or 2 (8­10 minutes). [. . . ]