User manual BOSCH MUM5XW10

[. . . ] Only take hold of the cutting discs by the edge. Never touch the sharp blades and edges with bare hands. Only use the pusher to push down ingredients. Never assemble the accessories on the base unit. [. . . ] Press the release button and push the swivel arm down until it engages in position 1. Press down the protective cover for drive 2 at the marking and remove. Before using for the first timeen Assembling the continuous feed shredder wARNING Risk of cutting!The cutting discs have sharp blades and edges. Only take hold of the cutting discs by the edge. Never touch the sharp blades and Never assemble the accessories Grip the disc holder level with the wings. Take hold of the required cutting disc by the edge and fit onto the disc holder with the side you require facing up. Fit single-sided discs with the blades or serrations facing up. Fit reversible slicing discs with the required marking facing up. Insert the disc holder with the cut- Place the lid on the housing. Rotate the lid clockwise until it engages. Fitting continuous feed shredder onto the base unit Ies once the drive has stopped and the appliance has been unplugged. Place the continuous feed shredder on drive 2 as shown. Push the continuous feed shredder down and rotate clockwise until it engages. 14 The continuous feed shredder must be securely connected to the base unit. You can find out everything you need to know about operating your accessory here. Observe the recommended speeds for optimum results. Note: Your model is equipped with a 4- or 7-level rotary switch depending on the features of the appliance. The recommended speeds for the 4-level rotary switch are always shown in brackets in these instructions for use. Shred food coarsely or finely using the reversible shredding disc, e. Processing food with the continuous feed shredder Do not reach into the filling shaft. Only use the pusher to push down ingredients. [. . . ] Finish processing and unplug from the mains. Take the accessory apart and remove the blockage. Cutting disc does not rotate Lid is not fitted and engaged Check whether the lid is fitted prop- Although the base unit is run- properly. "Assembling the continuous feed Accessory has been overloaded and the disc holder shaft has broken at the predetermined breaking point. [. . . ]