User manual BOSCH NCT615C01 INSTALLATION INSTRUCTIONS

[. . . ] cluttered or dark areas invite accidents. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. C) Keep children and bystanders away while operating a power tool. [. . . ] Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. check the operation of the lower guard spring. If the guard and the spring are not operating properly, they must be serviced before use. Lower guard may operate sluggishly due to damaged parts, gummy deposits, or a build-up of debris. Lower guard should be retracted manually only for special cuts such as "plunge cuts" and "compound cuts". Raise lower guard by retracting handle and as soon as blade enters the material, the lower guard must be released. For all other sawing, the lower guard should operate automatically. It is not designed for operation with a saw table. Do not use high speed steel (HSS) saw blades. When working with the machine, always hold it firmly with both hands and provide for a secure stance. The power tool is guided more secure with both hands. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] Excessive feed significantly reduces the service life of the saw blade and can cause damage to the power tool. The following work steps are required for exact cuts using the guide rail 27: ­ Place the guide rail 27 on to the workpiece projecting lightly over the side. Pay attention that the side with the rubber lip faces to the workpiece. Two guide rails can be connected to one with use of the connection piece 28. [. . . ]