User manual BOSCH NGU4151DT

[. . . ] Before starting the machine, check that all screws, nuts, bolts and other fasteners are properly secured and that guards and screens are in place. replace damaged or unreadable warning and operating labels. Before starting the machine, make certain that the feed intake is empty. Keep your face and body away from the feed intake opening. [. . . ] Do not allow children to operate this equipment. Other persons and animals should remain at a distance of 3 metres or more when the machine is being used. The operator is responsible for third persons in the working area. Bosch can assure flawless functioning of the machine only when original accessories are used. Become familiar with the owner's manual before attempting to operate this machine. Avoid wearing loose-fitting clothing, hanging cords or ties. Only operate the machine in open space (eg not too close to a wall or other fixed objects) and on a firm, level surface. Do not operate the machine on paved or gravel surface where ejected material could cause injury. Shredder Part number (TYP) Rated power, S 6 (4/6 min)1) Rated power, S1 No-load speed Capacity max. The S 6 operating mode (40 %) indicates a load profile of 4 min load and 6 min idle time. Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled. Small pieces of shredded material may be ejected from the feed intake. Ensure eye protection, protective gloves and ear protection are used when using the machine. Only insert as much material so that the feed intake 1 will not be blocked up. Do not fill soft waste such as kitchen rubbish into the shredder but compost directly. Take care that the chopped material can fall freely from the discharge chute 8 ­ danger of backing up!The ventilation slots 5 must not be covered by the collecting bag or the chopped material. Avoid blocking the discharge chute 8 with shredded material as this could result in kickback of material through the feed intake opening. The blade continues to rotate for a few seconds after the machine is switched off. Allow the motor/blade to stop rotating before switching "on" again. Starting: To start your Shredder, rotate the On/Off switch 2 from position "0" to position "II". Allow machine to start and release switch, which will return to position "I" (the normal run position). [. . . ] Carry out necessary maintenance or repairs before using. If the machine should happen to fail despite the care taken in manufacture and testing, repair should be carried out by an authorised customer service agent for Bosch garden products. For all correspondence and spare parts orders, always include the 10-digit part number (TYP) from the nameplate of the machine!Stop and remove plug from the power supply. [. . . ]