User manual BOSCH PAS 12-27 REV 9-2009

[. . . ] water entering the vacuum cleaner increases the risk of an electric shock. When operating the vacuum cleaner in damp environments, use a residual current device (RCD). Using a residual current device (RCD) reduces the risk of an electric shock. If damage is found, replace the cord before further use. [. . . ] Typically the A-weighted sound pressure level of the product is 77 dB(A). We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60335 according to the provisions of the directives 2006/95/EC, 2004/108/EC. 1 Cable holder 2 Carrying handle 3 Socket for power tool (PAS 12-27 F) 4 Latch of the vacuum cover 5 Container 6 Vacuum hose 7 Release button for hose connection piece 8 Hose connection piece 9 On/Off switch (PAS 11-21/PAS 12-27) 9 Mode selector switch (PAS 12-27 F) 10 Vacuum lid 11 Permanent filter 12 Float 13 Accessory holder Container volume (gross) Dust bag contents Vacuum* Airflow* Dust category (BIA) Weight according to EPTA-Procedure 01/2003 Protection class For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your vacuum cleaner. The trade names of the individual vacuum cleaners may vary. Before any work on the vacuum cleaner itself, pull the mains plug. note: For vacuuming , the permanent filter 11 always must be inserted. In addition, the dust bag 14 must be used when dry vacuuming. Make sure that the full length of the dust bag 14 faces against the inner wall of the container 5. When using a dust bag 14, the permanent filter 11 remains unclogged longer, the vacuuming performance is maintained longer, and the disposal of dust is made easier. ­ Pull off the full dust bag 14 from the connection flange toward the rear. Close the opening of the dust bag by folding down the lid. Remove the closed dust bag from the vacuum cleaner. Insert the vacuum hose 6 into the hose connection piece 8 until it is locked. English | 15 Insert the accessory holder 13 from above onto the holder of the vacuum lid 10. Afterwards, insert the angle piece into the accessory holder 13 from the bottom until it can be heard to latch. For disassembly of the accessory holder 13, press the ends of the angle piece together and pull it out towards the bottom. remove the accessory holder 13 to the top. Operation with remote automatic switching (see figure B) (PAS 12-27 F) A socket outlet with earthing contact 3 is integrated in the vacuum cleaner, which allows for connection of an external power tool. The vacuum cleaner is automatically put into operation via the power tool. Observe the maximal allowable load of the connected power tool. set the mode selector switch 9 to position "II". [. . . ] Press the plastic basket 15 firmly into the new permanent filter 11. Container Wipe out the container 5 from time to time with a commercially available, non-scouring cleaning agent and allow to dry. If the vacuuming performance is not achieved thereafter, take the vacuum cleaner to customer service. Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. [. . . ]