User manual BOSCH PBH 2800 RE REV 9-2009

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1) Work area safety a) Keep work area clean and well lit. [. . . ] Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 98/37/EC (until 28 Dec 2009), 2006/42/EC (from 29 Dec 2009). Article number Speed control Stop rotation Right/left rotation Quick change chuck Delivery Scope ­ Keyless drill chuck Rated power input Impact frequency at rated speed Impact energy per stroke Rated speed No-load speed ­ 1st gear ­ 2nd gear Tool holder Spindle collar diameter Drilling diameter, max. : ­ Concrete ­ Brickwork (with core bit) ­ Steel ­ Wood Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm mm mm kg W min-1 J min-1 min-1 min-1 ­ ­ 720 4000 0­2. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. Before any work on the machine itself, pull the mains plug. PBH 3000-2 FRE: The SDS-plus quick change chuck 2 can easily be replaced against the quick change keyless chuck 1 provided. Operate your machine only with the auxiliary handle 17. Rotating the Auxiliary Handle (see figure A) The auxiliary handle 17 can be set to any position for a secure and low-fatigue working posture. Turn the wing bolt for adjustment of the auxiliary handle 16 in anticlockwise direction and set the auxiliary handle 17 to the required position. Then tighten the wing bolt 16 again in clockwise direction. Adjusting the Drilling Depth (see figure B) The required drilling depth X can be set with the depth stop 18. Otherwise, the movability of the SDS-plus drilling tool can lead to incorrect adjustment of the drilling depth. ­ Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop correspond with the desired drilling depth X. To work with drilling tools without SDS-plus (e. , drill bits with cylindrical shank), the key type drill chuck or the keyless chuck must be mounted. Mounting the Key Type Drill Chuck (Accessory) (PBH 2800 RE) (see figure C) ­ Screw the SDS-plus adapter shank 22 into a key type drill chuck 21. Secure the key type drill chuck 21 with the securing screw 20. please observe that the securing screw has a left-hand thread. Inserting the Key Type Drill Chuck or the Keyless Chuck (see figure D) ­ Clean the shank end of the adapter shank and apply a light coat of grease. [. . . ] To work with screwdriver bits, a universal bit holder 33 with SDS-plus shank (accessory) is required. Clean the shank end of the adapter shank and apply a light coat of grease. ­ Insert the universal bit holder with a turning motion into the tool holder until it automatically locks. Use only screwdriver bits that match the screw head. [. . . ]