User manual BOSCH PCM 7 REV 3-2009

[. . . ] Do not use the laser viewing glasses as sun glasses or in traffic. The laser viewing glasses do not afford complete UV protection and reduce colour perception. 10 Battery lid 11 Laser warning label 12 Tripod* 13 14 15 16 17 18 19 Wall holder* Unlocking buttons of the holding plate* Holding plate of the wall mount* Fastening screw for wall mount* 1/4" screw of wall mount* Laser viewing glasses* Protective case A complete overview of accessories can be found in our accessories program. Only use batteries from one brand and with the identical capacity. [. . . ] To switch off the measuring tool, push the On/Off switch 7 to the "Off" position. When switching off, the levelling unit is locked. Do not leave the switched on measuring tool unattended and switch the measuring tool off after use. Other persons could be blinded by the laser beam. Please observe the article number on the type plate of your measuring tool. The trade names of the individual measuring tools may vary. When inserting, pay attention to the correct polarity according to the representation on the inside of the battery lid. After switching on, the measuring tool is in crossline operating mode with automatic levelling. to change the operating mode , press the "Mode" button 6 until the requested operating mode is indicated by the corresponding illuminated operating-mode indication 5. The following operating modes are available: Indication Operating Mode Cross-line operation with automatic levelling (see figure A): The measuring tool generates both a horizontal and a vertical laser line; their levelling is monitored. Horizontal operation with automatic levelling (see figure B): The measuring tool generates a horizontal laser line; its levelling is monitored. The laser viewing glasses do not afford complete UV protection and reduce colour perception. Working with the Tripod (see figure H) A tripod 12 offers a stable, height-adjustable measuring support. Place the measuring tool via the tripod mount 8 onto the 1/4" male thread of the tripod and screw the locking screw of the tripod tight. Working with the Wall Mount (Accessory) With the wall mount 13, the measuring tool can be securly attached at any height. Mounting the wall mount (see figure I): For fastening to a wall, the holding plate 15 must be folded out. Press pushbuttons 14 on both sides of the holding plate (a), fold the holding plate up (b), lightly push it downward and allow it to latch (c). For height adjustment of the measuring tool, the holding plate 15 can be moved up or down within a range of 6 cm. For this, press the pushbuttons 14 on both sides of the holding plate, slide the holding plate to the requested height and allow it to latch again. the scale on the side of the wall mount aids the height adjustment. Fastening the wall mount (see figure J): Fasten the wall mount 13 as vertical as possible to a wall with the holding plate 15 folded up. Secure it safely against slipping off, e. [. . . ] In all correspondence and spare parts orders, please always include the 10-digit article number given on the type plate of the measuring tool. Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. Exploded views and information on spare parts can also be found under: www. Com Our customer consultants answer your questions concerning best buy, application and adjustment of products and accessories. [. . . ]